(800) 853-2651
SHOP NOW

Recent content by fastline

Yesterday's Tractor Forums
  1. F

    No brakes on 1170

    I realized that I indeed paid for an Emanual, then lost it in a drive failure.....my life. I reviewed the last time I discussed the brakes on here and there was a check valve mentioned off a plastic line connected to the bottom front of the brake valve. I can only surmise that is a sort of a...
  2. F

    No brakes on 1170

    Hoping someone with experience still hovers here. I've had this 1170 for several years. At first the brakes needed primed after sitting too long. Now it basically has no brakes. If I pump pedals, the left will partially come back but it will lose prime shortly. Calipers don't leak. I am...
  3. F

    Case 1170 hydraulic specs?

    I checked routing on that 5th hydro port and oddly, it goes to the valve block for the loader? I've never used it, so sort of a mystery. Basically I am building a water well rig. Hydro motor for the drive, other remote for hydraulic lift, setup will mount on the 3pt and probably have to...
  4. F

    Case 1170 hydraulic specs?

    Thanks. Any word on design pressure in these? Also, there is a 5th hydro port I believe to be for a direct drain? However, I will need to reverse the motor so not sure it would be practical to plumb one side to drain. I could possibly install a temp gauge. But if memory serves, I...
  5. F

    Case 1170 hydraulic specs?

    Without diving too deep, I am wanting to possibly run a hydraulic motor off a remote on the tractor. It would probably run at the maximum output at about an 80% duty cycle for a couple hours. I am not sure if the tractor is really intended to handle that sort of hydraulic demand? All I...
  6. F

    Looking for gurus on an old CAT D7. Big issues, need a

    I'm sure it is like any topic online, just depends on who you can find. My resident guru passed a few yrs ago, and was just super sharp on the old equipment. I have found some help here and there, and I gather the pieces as I work. No biggy as I realize memory can be sketchy and these old...
  7. F

    Looking for gurus on an old CAT D7. Big issues, need a

    So you are saying pull that plug and fire machine up?
  8. F

    Looking for gurus on an old CAT D7. Big issues, need a

    That is a pressure test tap on the top of the trans pump.
  9. F

    Looking for gurus on an old CAT D7. Big issues, need a

    Been on another forum but just sniffing around the web trying to find folks that know these old machines. They are getting hard to find! This is an old E model, 48A, powershift, etc. I bought it needing work but did not know the trans cooler failed. Right now I have a trans input shaft that...
  10. F

    Alright you Case nuts, what do you know about LP tractors??

    Well, I checked it out and bought it. Tank had the badge on it that showed 65gal and I ran the dimension calculations and came up with about 63.5gal which was just a quick calc so I guess she is a 65 with 85% in it. Now we are just working to figure out how to move it. Just a little...
  11. F

    Alright you Case nuts, what do you know about LP tractors??

    LOL, hoping you guys can kick over some quick advice. I need a mid size LP tank to run a job trailer. Due to the friggin Covids, we are way behind with the new shop build. I cannot continue trying to run on these little BBQ tanks, and a stationary tank would be in the way, about anywhere...
  12. F

    HELP! My 1170 is down and I need it! Blew hydro line.

    RG had same thought on all rubber hose. Can't edit my posts but didn't want to leave someone out. I just hope I am over thinking it. Usually when I go in hot, with everything from a scalpel to a cutting torch, the job gets done much better. It's those jobs that "should" take 10min and...
  13. F

    HELP! My 1170 is down and I need it! Blew hydro line.

    Thanks guys! Clint, that is a good idea to just use all rubber. Yes about the cowling. If there is some sort of "hood" over the air cleaner, I don't have one. The air cleaner sticks up past the cowl and it just looks unfinished. Anyway, I can see that if I remove the air cleaner, I...
  14. F

    HELP! My 1170 is down and I need it! Blew hydro line.

    Get right to the point. Using it for several things right now and was turning in the field when I heard a bang, the steering wheel was ripped from my hand, and it started spraying oil, some in the cab. Of COURSE it is not a easy repair! Nothing on the tractor is easy. Took 15min just to find...
  15. F

    Help with dash gauges in Case 1170?

    Thanks Rod, I found that canister just before checking back online. That is going to SUCK to work on. All my FIL hoses and connections are in there, and the FIL mounts. I think I saw that needle getting in the red and shut down! Is the right side actually LOW pressure by chance? Reason...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top