(800) 853-2651
SHOP NOW

Recent content by FBH44

Yesterday's Tractor Forums
  1. F

    Do you ever get over Lyme disease

    I'm 79 and I have to stop and remember sometimes too. Annoying.
  2. F

    Thursday Cheese Market

    Went thru there many years ago. It is pronounced Hooda by the Dutch.
  3. F

    long line at tire store

    Bicycling across the Rockies many years ago we told a girl she had to stop on the Continrntel Divide and change her tire air from West air to East air. Hard to believe, but we caught up with her on top of some pass or other, and she was pumping a rear tire back up ..... True story.
  4. F

    Cub Cadet GT2550

    yes, thank you. They do still glow, i'VE READ there is a capacitor inside the LEDS, THAT POWERS THEM FOR A WHILE,
  5. F

    1020 rear axle housing grease zerks

    I realized some time ago that there are many different kinds of zerks. Different sizes, some threaded, some drive-in, some long, some short. I bought an assortment, keep them in a Plano plastic tray, with different comaprtments. I can select the right one.
  6. F

    Cub Cadet GT2550

    I have an odd thing; I put on LED lights, run directly off the battery thru a fuse, and they work great. Now however, when I shut off the motor, the lights glow very dim. Cannot be shut off. Also, and I may be wrong about this, but when I come in from mowing grass, the mower deck stays on...
  7. F

    Cockshutts

    Handsome tractors.
  8. F

    Unbelievable Prices

    I woulda ordered some spares.
  9. F

    Steering wheel removal on IH Utility 300

    Patience. Puller on, heat, more pressure, leave it and come back in few hours, more torque, more heat, come back. Patience.
  10. F

    Learning things

    Yeah, I learned the hard way that the 4-bolt offset taper-bolt plate thing in the drive train of the H Farmall, can be isntalled two ways; with minimum space in there, and with maximum space. DO NO INSTALL it with the minimum space; the end of the drive shaft will not fit into the pilot bearing...
  11. F

    IH 300U - Carburetor...curiosity

    SOAK IN VINEGAR FOR A WEEK OR TWO.
  12. F

    1951 Farmall H - no Liftall

    I never understood it, but ordinary lumber-yard plumbing fittings and pipe nipples could withstand the Liftall pressure. I thought the Liftall pressures were 600 - 800 psi, but regular fittings seem to work.
  13. F

    Some scenes and faces from Rusty6 country

    Wonderful. THanks.
  14. F

    Back to my flat tire

    Yeah but it aint that simple. When the tire expands and contracts, V is not constant, and V directly changes. Also, that is a perfect gas equation, and air isn't perfect.
  15. F

    H thermostat

    My 1950 H never did warm up until I put on a set of shutters. Now she's just fine.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top