(800) 853-2651
SHOP NOW

Recent content by fhoehle

Yesterday's Tractor Forums
  1. F

    Case 530 Trans shaft runout

    Yeah same here on the worrying bout the direction of our country. No chinese made junk will ever dig as many holes as this old backhoe has.
  2. F

    Case 530 Trans shaft runout

    I was looking in my Case 530 Trans when I pulled the covers off just to check it all out and clean it. Fluid perfect, no shavings, bearings all tight, gears all great. I started it, just to watch things go around, and noticed a bit (not much) of runout in the shaft which seems to go to where a...
  3. M

    hd4

    will allis chalmers m chain work on a hd4 or does anyone know where i can get a set of chains for it thanks mike
  4. F

    Farmall Head ID...400???

    the combustion chambers on the lp head will definately be smaller than a gasoline head. I dont think i"d buy it if casting No"s are ground off..kind of a pig in a poke.
  5. F

    M Farmall compression

    Autolite 3116's. never had luck with Champs orDelcos. never fouled an Autolite yet.
  6. F

    Farmall A question

    I know in our area there are a few little A's and B's (and lot of C's) in the light classes, and they seem to do well. I do not know the specifics, but there is a c 135 engine that seems to be in the C-113 family, and I believe there is one size larger than this. My buddy's 340 farmall has a...
  7. F

    tow vehicle

    Heck, you dont need a new vehicle to tow with, especially if its a second truck, get an older medium duty truck, and get the reward of a straight frame, a good diesel (like a DT466) and the best part, a low or no payment. I bought a 7100 IH with a 466 and a 7 spd trans for 6500.00 good luck and...
  8. F

    tow vehicle

    Heck, you dont need a new vehicle to tow with, especially if its a second truck, get an older medium duty truck, and get the reward of a straight frame, a good diesel (like a DT466) and the best part, a low or no payment. I bought a 7100 IH with a 466 and a 7 spd trans for 6500.00 good luck and...
  9. F

    M Farmall compression

    that seems a little low. I put mine together about 3 or 4 yrs ago, with Tisco step head pistons and a gas head and use it regularly for working and pulling. after it was run for about 20 hrs or so, the compression settled where it is at, and never varied since. Always even across cyls. Just...
  10. F

    M Farmall compression

    I would like to know how much difference a LP head makes on M farmalls (horsepower). I have Tisco step-head pistons and sleeves for a 450 in my M (Bored block to do it) and a 400 Gasoline head on it. I've had Dennys do the cam (fairly mild grind) I've done carb, dist, and governor to match. I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top