Recent content by fireman176

  1. F

    TO30 lift arms slow to respond

    When bush hog connected and i go to lift it, it doesnt react immediately but takes a few seconds and doesnt appear to lift unless pto engaged. Sorry but new user.
  2. F

    TO30 lifting problem

    My bushhog will not stay at my selected level, it will raise to full extension and I can lower it and it will stay a few seconds and continually raise and lower. What is likely the problem?
  3. F

    Radiator leaking on TO30

    I did not look that close the other day but it looked like it was coming from radiator because water was collecting in bottom of shroud area and blowing around with fan turning. I will look closely, but it is parked at hunting camp 100 miles away.
  4. F

    Radiator leaking on TO30

    Radiator fins look rough but up till now it hasn't leaked, but noticed the other day coolant running down on trailer. I topped her off and some still leaks out in a steady stream. Can it be fixed or do I need a new radiator and if I need a new one where can I get one?
  5. F

    Trying to post picture

    Trying to post a picture. can't seem to do it from my phone. Supposed to be a smart phone but seems stupid today.
  6. F

    51 TO30 painted at last

    Got my 51 painted the gray it supposed to be, instead of the JD green someone before me painted it.
  7. F

    Black Diamond sandblasting media doesn't work for me.

    bought the same brand when I bought their cheap sandblaster and figured out that the pickup hose was too large to suck the media blaster all the way to the tip so I just put a piece of duct tape over bottom of pickup hose and poked a smaller hole in duct tape to make the pickup smaller and it...
  8. F

    Fuel drips from glass bowl on fuel shutoff

    hanks for good advice.
  9. F

    Fuel drips from glass bowl on fuel shutoff

    What type gasket can I use to seal it?
  10. F

    Where to locate part

    ES, part 22 & 23
  11. F

    Where to locate part

    his is exactly the part, thanks so much. I think I have learned I can remove the ball joint end off the broke shaft and just get a threaded rod that the ball joint will fit onto and make it work.
  12. F

    Where to locate part

    TO30 1951 model. The linkage that connects the governor broke where it threads into the part surrounded by compensating spring. I looked on YT parts page and could only find the spring. Any suggestions? The threaded rod broke off about an inch from end of rod and I might be able to find someone...
  13. F

    Sent wrong parts "Again"

    esterdays tractors. 1st order screw up my fault because I couldn't tell them if spline was a 1 1/8 or 1 3/8 and I measured wrong. 2nd order was the warehouse packers fault by putting an unidentified clutch disc with no markings on the box in place of the correct disc. Still waiting for my disc.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top