-
F
Help needed near Gettysburg!
Got a customer who is taking a tractor to DC for 4th! He stopped in Gettysburg for photo shoot now tractor won t restart(860). He is not very mechanical and not understanding the trouble shooting over the phone -
F
Need an Inj pump for 201 diesel
I found a rebuilt 201 just needs inj pump, I don't care if it's from 4000, 4600. Heck I might even throw a Simms from a 3000 on it if need be I can reset the fuel cause I have the drive gear set up for a Simms on the shelf If ya got one layin around let me know or if ya need a motor I might... -
F
Bushings on rest-o- ride
Roll loc sanding disc and a die grinder to shave off OD of bushing is easier since that is spring steel -
F
Bushings on rest-o- ride
But not when side springs have been welded like ones pictured -
F
For the fanatical painters.
65 and newer grey. Would like to see it on my shelf too but little high for me.- forddoc
- Post #1
- Forum: Ford 9N, 2N & 8N
-
F
Worst possible tractor
How close to me were ya Jerry? Hey we converted a RC to a utility a while back so I will have what ya need to make that platform work with your 8 spd. -
F
8000 Filter Upgrade Template
Yep sent him an email but ricks had his not available. When it comes to most any special tool upto the 10 series we have. Ag and industrial, even built our own limp home harness for 40 series after local dealer wouldn't let me borrow but ohm it. -
F
Help needed, info on Sway bar for 246 planter on a 430T
Thanks will do this morning!- forddoc
- Post #1
- Forum: John Deere
-
F
8000 Filter Upgrade Template
Just used ours last month I even bet I could drop it in the mail in a flat rate box for you. As long as you send it back cause you know the last one we did before that was 1983. :) -
F
Help needed, info on Sway bar for 246 planter on a 430T
A kid in FFA that works for us has fully restored his grandad's 1958 430T, now he is trying to finish the restoration of his 246-247 planter. But his dad recalls a sway bar or stabilizer bar that mounted under the center of the tractor above the drawbar and then layed in a notch on the planter...- forddoc
- Thread
- Replies: 3
- Forum: John Deere
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy