Recent content by forrest allen

  1. F

    Farmall Cub Steering Gears

    Thanks for the response. I hope that I don't need to do it but your description will help if I do. Thanks
  2. F

    Farmall Cub Steering Gears

    That diagram is helpful. Thanks
  3. F

    Farmall Cub Steering Gears

    What was the solution to getting the gear out? I may be facing that task soon.
  4. F

    Farmall Cub float setting

    Lots of issues but the biggest was low compression. Rustred suggested that I put it in gear and drag it around a bit. That broke up some of the crud inside and compression came up considerably. Then we added fuel and pulled it and it started within about 20 feet. After that it would start on...
  5. F

    Farmall Cub float setting

    Plug wires look good and I have good spark. Initially I had two valves that were stuck. Didn't take much to get them moving again and I spent quite a bit of time working them to until I was satisfied that they were not sticking again. I feel good air movement on each cylinder.
  6. F

    Farmall Cub float setting

    Thanks. The tank looks clean. I may try the hose test.
  7. F

    Farmall Cub float setting

    Spark looks good. It is 6 volt. I cleaned the grounds and got the starter spinning nicely. 6 teaspoons of gas in each cylinder? Seems like a lot. And thanks for your time and help on this.
  8. F

    Farmall Cub float setting

    It's now dark enough that it will need to wait till tomorrow. The tractor was running nicely when parked (I know because I parked it) but that was a few years ago. It's been in a shed since. I did find a bug or something in the carb when I opened it the first time last week. While was previously...
  9. F

    Farmall Cub float setting

    Suction and wet but gas is flooding out again.
  10. F

    Farmall Cub float setting

    Either the needle is sticking now or the float is hanging up. I opened the main jet and no gas. Tapped on the carb and got gas but still won't fire. I will pull the plugs.
  11. F

    Farmall Cub float setting

    I did. I installed it and it's at the almost point. It fired and tried to start but didn't. I got the best result by increasing the throttle half way so I think it's still starving for fuel. It isn't flooding out the carb now though. I tried 1, 1.5, and 2 turns out on the needle. Not much...
  12. F

    Farmall Cub float setting

    Look again. I uploaded the wrong file.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top