-
F
John Deere 5065e
Toe is good camber looks off but nothing can be done about that. It is 4x4 with loader. Travel 2 miles a day on hard top feeding cattle. Just put new tires on last week got about 1200 hrs out the last set- foxhoun
- Post #8
- Forum: Tractor & Farm Talk
-
F
John Deere 5065e
My 5065e is wearing the tires out on the front on the outside of the tread. Checked the tow and that was perfect. It almost looks like the camber is off on both front tires. As far as I know there is no adjustment on the camber. Anyone got any help on this issue? Thanks- foxhoun
- Thread
- Replies: 22
- Forum: Tractor & Farm Talk
-
F
NH br7060 round baler
My 7060 round baler will stop when The bale is full but will not wrap it or count the number of bales. I can wrap the bales by extending and retracting the duck bill Anyone have an idea where to start correcting this problem. Thanks Foxhoun- foxhoun
- Thread
- Replies: 15
- Forum: Implement Alley
-
F
john deere 5065e
looking for help on locating and changing crankcase vent filter on my 5065E. There is a little oil blowing out the dipstick hole.There are no alarms indicating there is a problem. JD tells me its in the front of the engine but its not. Thanks in advance Foxhoun- foxhoun
- Thread
- Replies: 1
- Forum: Tractor & Farm Talk
-
F
John Deere 6115d
Can anyone give me some information on where the speed sensor is on a John Deere 6115d. It drops mph to 0 then goes in neutral Thanks in advance- foxhoun
- Thread
- Replies: 1
- Forum: Tractor & Farm Talk
-
F
John Deere 6115d
Can anyone tell me how to change from kph to mph in this model tractor Thanks Foxhoun- foxhoun
- Thread
- Replies: 3
- Forum: Tractor & Farm Talk
-
F
5610 electrical
Makes sense I havent tried that. Will test V to switch next Thanks- foxhoun
- Post #1
- Forum: Tractor & Farm Talk
-
F
5610 electrical
I put 12v on the wire I thought to be FL it tested good. But I plan on digging deeper to find the issue. The wire I thought to be FL has a coating unlike the other wires Thank you Foxhoun- foxhoun
- Post #1
- Forum: Tractor & Farm Talk
-
F
5610 electrical
That just might be the case. I will recheck Thanks- foxhoun
- Post #1
- Forum: Tractor & Farm Talk
-
F
5610 electrical
It plugs in to solenoid but cant very if its outside or inside. I think I miss spoke earlier. I will try to get a photo Thanks- foxhoun
- Post #1
- Forum: Tractor & Farm Talk
-
F
5610 electrical
The FL is connected to the solenoid with s spade tip connection. There is no voltage where the FL plugs into. It dos not connect directly to the battery connection on the solenoid- foxhoun
- Post #1
- Forum: Tractor & Farm Talk
-
F
5610 electrical
I will check them out. Had a hot wire that grounded out to sheet metal that caused the problem Got 12v going into solenoid Thanks Foxhoun- foxhoun
- Post #1
- Forum: Tractor & Farm Talk
-
F
5610 electrical
I have verified the the fusible link is good but I dont have any voltage where the link connects to the solenoid. Got voltage from battery to solenoid. Thanks Foxhoun- foxhoun
- Thread
- Replies: 15
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy