-
garethbell3 replied to the thread 706 MCV damage.Finally got some free time. Heres a before and after of both holes with the JB weld. Got it very smooth and blended. Should do the job -
-
Hello everyone, i have a bushhog 2846 loader on my 706. Im needing a bale spear for it to stack bales in the barn with. Am i limited to...
-
-
If possible, I might still use a stud. But that might make it difficult to install that cover.
-
garethbell3 replied to the thread 706 MCV damage.I appreciate everyones help and time taken to respond to my posts. Honestly if the name calling stuff has to happen just do it in a...
-
Well i have gone the OTHER way and gone out to 3/8ths I had one guy literately BLOW the M C V clean off the tractor when he messed with...
-
Now now M CV bolts are 5/16 ths grad five BUT i have see some that WERE GRADE 8 . And as for the casting repair i prefer LAB Metal ...
-
garethbell3 replied to the thread 706 MCV damage.Being that im in a hay barn with no power or lighting JB weld outa be good enough! I was thinking that route but needed someone else to...
-
garethbell3 replied to the thread 706 MCV damage.Plenty of threads left in there surprisingly. So i guess just getting a nice surface for the gasket is the main concern
-
garethbell3 replied to the thread 706 MCV damage.I was thinking JB weld might be a viable option as well. Probably the route ill end uo taking, i appreciate you! This has been one of...
-
Caused by a moron with too short of a bolt, would be my guess. Are there threads deeper where you could use a stud. Mrfred54 sounds...
-
Yup, wrong bolt was used in those holes. Have repaired this kind of damage before. Use JB weld. Fill the threaded hole and the gasket...
-
Pulled off my MCV today on my 706 to begin a rebuild/ pump replacement. One of the bolts on the MCV was a replacement bolt with a ton of...
-
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy