(800) 853-2651
SHOP NOW

Recent content by gatractorelli

Yesterday's Tractor Forums
  1. G

    Coil Hot - Wrong 12v sent

    Hi, Well found the new distributor pins were not contacting the rotar so had no spark, had to reset the pins and ensure the gap was correct. The engine turns over but wasnt getting cranked or lack of staying cranked. Resolved the ignition issue but still have the staying cranked, replacing...
  2. G

    Coil Hot - Wrong 12v sent

    Replaced coil, battery, starter solenoid, push botton and it cranks no problem. Now seems my carb is an issue so making progress.
  3. G

    Coil Hot - Wrong 12v sent

    *Raise hand* I am the newbie.
  4. G

    Coil Hot - Wrong 12v sent

    I fully removed the coil after discovering how hot it was. I am replacing the coil and starter solenoid with the correct part numbers. Will update once I get everything and installed.
  5. G

    Coil Hot - Wrong 12v sent

    Part should be 105677, weird their description on the site for the now 105690part: Starter Solenoid, 6 Volt - This is a 4 post, 6 volt starter solenoid relay assembly. It has a flat mount. Insulated Base, does not ground through mounting bracket. Will work in tractors converted from 6 to 12...
  6. G

    Coil Hot - Wrong 12v sent

    Okay, point taken on the conversion. The coil I received requires an external resistor which I plan to change out for one that doesnt require.
  7. G

    Coil Hot - Wrong 12v sent

    So first, this is a hobby not a job for me. I enjoy figuring it out and seeing the results. Second, if the part shows internal resistor for a coil then I expect that is what it means. If mechanics around the world think differently, okay sure. Third, I actually called into the YDT and...
  8. G

    Coil Hot - Wrong 12v sent

    Ford NAA My Coil was not labeled. I didnt leave the switch on, only turned on when tried the starter button. 105282 Distributor Coil 12 Volt 105689 Starter Solenoid Ford Style 12 Volt 4 105687 Ignition Switch New Alls Chlmrs 70225310 103141 Alternator Conversion Kit, New, Ford 112209 Starter...
  9. G

    Coil Hot - Wrong 12v sent

    I have doubled check the wiring as its all new since I am rebuilding every single part of the tractor, including the engine. I will replace the start switch as well just to be sure. I tested power to the start solenoid and got 12V, but didnt get anything on the other side of the starter...
  10. G

    Coil Hot - Wrong 12v sent

    The coil was 12v, just no resister built in.
  11. G

    Coil Hot - Wrong 12v sent

    Well, I couldnt figure out why when I hit the starter switch I got nothing, drove me crazy till I touched the Coil. It was burning hot, come to find out they sent me a coil without a resister built in so it was draining the power from the battery. Freaking Yesterday Tractor!!!
  12. G

    Ford NAA - Vertical Exhaust Installation

    Can you show how its mounted?
  13. G

    Ford NAA - Vertical Exhaust Installation

    Hi, thanks for the info. I may have to reach out to YT and have them replace the setup. Lots of time spent already on the project, would like to start it up.
  14. G

    Ford NAA - Vertical Exhaust Installation

    Hey, The band clamp does not hold the pipe in, even tighted down. It bottoms out as you can see and the vertical exhaust moves without the u clamp. I was surprised as well and questioned the design to YD but they said there is no further information on installation so I had no choice.
  15. G

    Ford NAA - Vertical Exhaust Installation

    Hi, The muffler bracket is specific to the Ford Manual and I had to get a new one sent out to me to support the muffler as seen in the picture
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top