(800) 853-2651
SHOP NOW

Recent content by gd2go1

Yesterday's Tractor Forums
  1. R

    900lp followed me home

    I know basically nothing about LP tractors or Cases older than my 1030... The only real problem I could find was a bad packing on the liquid valve on the tank. I have new valves on the way. I have been driving it around on vapor off of a 20# tank. Seems to run really good as long as I...
  2. 4

    Case Starter Bendix removal

    Anybody remove the bendix gear/teeth from the armature? Looking for a starter and I cana find 9 tooth starters, if i can remove my 10 tooth bendix and place it on the new armature, viola!, new starter. Just need to be able to remove bendix.
  3. C

    lt0-300 military surplus welder

    I have run across a military surplus welder that's quite reasonably priced. The welder part is made by Libby and has a 300 amp output. The power comes from a 4AO84 air cooled engine. Turns over but no spark. Overall looks in decent shape. Anyone have experience with these and their good and bad...
  4. J

    6v battery reversed charged

    hello, im working on a friends 8n with a 6v system. he reversed charged his battery after it went dead. im working on the engine for a blown head gasket and was going to charge the battery while its down for repair. he did not complain of a charging system problem. when I correctly discharge and...
  5. S

    Rock auto prices

    Has any bought from Rock auto. I was looking at two items, both Trico Winter Wiper Blades. Locally the blades are around $18. Rock Auto had them for under $5 each. Seems very low I wonder what the catch is.
  6. L

    dearborn 10-161 plow

    Hello folks- Anyone out there know where I could get a replacement landslide for the Dearborn 10-161 2 bottom plow? I need the back one. Much obliged. Steve
  7. B

    4020 repair restoration

    Been doing a restoration repair to my 1970 4020 tractor I found a small cone shaped thing in the bottom of the diff housing I can not find where it came from wondered if anyone here might know what it is or where it goes I will include a pic
  8. N

    .030 under bearings for M

    Anyone know where I can find .030 under crank bearings for an early M? They measure 2.714 - 2.718.
  9. G

    VAC-14 Detent Hydraulic Valve

    In cleaning out my eagle hitch cylinder I found a ball bearing measuring about .010" stuck to some grease at the top. Is this for a detent in the control lever, or someplace else? Thank you, Glenn F.
  10. B

    White 2-70 transmission input shaft

    This morning while using my white, the sprocket coupler seems to have taken off all the splines on the input shaft to the transmission. I have a workshop manual for a 1655, but it's not real clear. Do you have to remove the engine and over/under to get the input shaft out of the transmission...
  11. Lumbersawyer

    WF Tranny

    I need to switch my transmission on my 37 WF. It looks like I need to either remove the engine or the rear end. The steering box is bolted to the top of a tubular housing that runs between the bell housing and rear end. I don't think a WC is the same as the WF, because the WF is shorter and the...
  12. jon f mn

    Somebody secretly recorded me this morning

    Kinda tired of this weather. What I looked like this morning
  13. B

    JD 3020 24volt light/short question

    I completed installation of a new 12 volt battery, hooked the 2 12volts in series (right battery negative to left battery positive) and established a positive ground off the left battery. Vola, the lights worked..until I started the tractor. I did some reading and polarized the generator by...
  14. G

    860-960 transmission interchange

    Will the transmission from a 960 work in an 860?
  15. 3

    PTO question

    Read the one post about the 540 and the 1000 PTO. Why did some tractors have two output PTO's? I had a guy ask that a while back and I did not have a really good answer for him. I knew the 1000 was or bigger equipment and the 540 for small items. Never really knew why there were two shafts...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top