(800) 853-2651
SHOP NOW

Recent content by GENE DERRINGER

Yesterday's Tractor Forums
  1. G

    JD 265 HARD STARTING

    Valves were set at 5. Going to try to shorten the choke cable setting. Thanks Dave, you were the only response I got!
  2. G

    JD 265 HARD STARTING

    My John Deere 265 has a 17 hp Kawasaki engine. It has alway started hard, but the electric shutoff went bad, so I replaced the complete fuel system - filter, fuel pump, and carburetor. I noticed that the choke was not completely closed when choked. When I hold the choke closed by hand, the...
  3. G

    RACOONS IN THE BARN

    I want to thank everone for all the replies. I really appreciate the help!
  4. G

    RACOONS IN THE BARN

    I want to get rid of raccons in my barn. I have barn cats which have done a good job of riddance of rats and mice. I have set live traps, but the cats get in the traps. Any suggestions would be appreciated. Thank you in advance. I am sure someone will suggest to burn down the barns. Not...
  5. G

    JD 2 CYL CUBIC DISPLACEMENT

    I want to thank all those who responded to my question. You were very polite. Thanks
  6. G

    JD 2 CYL CUBIC DISPLACEMENT

    What is the largest cubic displacement in the JD two cylinder pulling tractors? How often is it required to be rebuilt? Inquiring mind needs to know!
  7. G

    TRACTOR WHEEL WEIGHTS

    This might be a dumb question, but I need to know! What are the identifying marks or numbers on the wheel weights that Custom Manufacturing used to put on the wheel weights they manufactured for their tractors? I am aware of the ones that had the the word custom in the casting. Did they put any...
  8. G

    What impact wrench to buy?

    The M18 is a beast!! I love it
  9. G

    SOLENOID REPLACEMENT

    Thanks to all for your help and advice.
  10. G

    SOLENOID REPLACEMENT

    I am replacing a 3 post solenoid with a four post - couldn't find a three post. Do I need to run a ground wire to the extra post? Thanks for any advice you can give.
  11. G

    2 bottom plow ID

    Plowman: I am looking for a JD land wheel that fits the JD 55 plow. This wheel is for a clutch lift plow. Do you know what I can buy one. Thanks
  12. G

    BREAKING IN NEW RINGS

    This might be a dumb question, but here it is anyway. How many hours under load does it take for new rings to "set" or "seat" in a 4020 gas engine. I want to do some light work, but not until it is "broke in. Thanks
  13. G

    DUMB QUESTION?

    When a seller of a JD gas 4020 knows that the sleeves and pistons are bad, if he is an honest seller, he or she would tell the buyer- correct? He may not know that all of the bearings are also bad, but there is a good chance of that. In this day and age, is it just "buyer beware" - you might...
  14. G

    Willian in Nevada

    I would insist on receiving some pictures, preferably with him in it! It would be interesting as to how he wants paid. If he insists to send by Walmart cash, etc. forget it!
  15. G

    quick haul recommendation

    Where are they located and how can one contact them? Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top