(800) 853-2651
SHOP NOW

Recent content by geoids

Yesterday's Tractor Forums
  1. G

    1030 runs out of diesel

    I"d say hand pump - My 1030 had the same problem. It didn"t take much crud in those discs to make it cough like that and lose power. 1070 had the crud in that elbow and had the same symptoms.
  2. G

    Re: Acid Wash for trailer?

    I used a cleaner called "purple power" on mine - got it at Rural King
  3. G

    1030 primer pump

    Thanks - that did the trick - all sort of junk clogging those small disks - some small metal wirelike pieces also. I dropped that small copper washer from the primer pump and had to search a while in the grass.
  4. G

    1030 primer pump

    I followed some of the suggestions posted here about fuel flow restrictions and found a lot of crud when I disassembled my primer pump. It ran free from the bottom of the tank and I replaced the 2 filters. Do the two primer pump discs get put back in facing in the same direction or opposite...
  5. G

    Backhoe hydraulics

    Correction ....... It's the MF220 backhoe diagram I'm looking for. I need to replace some seals on the control and relief valves.
  6. G

    Backhoe hydraulics

    Can anyone help with a drawing of the MF32 backhoe hydraulics.. I'm starting to get some leakage from the controls. Is there a relief valve for the backhoe or do the backhoe and bucket share the same one? (and where is it?) thanks for any help
  7. G

    OT Appliance Forum

    try.......... http://forum.appliancepartspros.com/
  8. G

    re gassing

    There are quite a few articles on this topic. Here's a good one: http://www.komar.org/bbq/mm/convert/dannos.html
  9. G

    OT - light diesel

    I was looking at some small diesel generators figuring I had plenty of diesel around the place. They said they run on "light diesel oil". Is that the same as 1K or closer to #1 grade? (road grade) Would it be any cheaper in the long run than the gas generator?
  10. G

    730 fuel tank leak

    I'vet got a leak on the bottom of my 730 gas tank. Is the fitting that the fuelbowl/filter screws into, threaded into the tank? or is there a nut on the inside? How do you tighten it if you need to replace the rubber seal?
  11. G

    Case - SC Parts

    You might try Glen Schueler in Texas. He can be reached at [email protected]
  12. G

    Ruger SP101

    I've got the hammer model - stock grips. no problem with the 38's - Keep a strong grip with the 357's for double action shooting - otherwise no problem either
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top