Recent content by glenn carpenter

  1. G

    farmall super A problem

    Got a "clunking" noise from left rear wheel area. What might the cause be?
  2. G

    Farmall Cub hydraulic system

    How do you remove the fluid from the hydraulic system?
  3. G

    Farmall Super A sticking gearshift

    Just started this spring, At first it wasn't too bad but steadily got worse. Shifting into and out of the other gears is OK
  4. G

    Farmall Super A sticking gearshift

    When I shift into 2nd gear tractor runs OK but when I try to shift out of 2nd gear, shifter does not want to move and I have to hit shifter with a bar to get it out of gear. What may be wrong? Thanks
  5. G

    knocking noise in transmission

    1947 9N tractor that had "low range" added to transmission. When in 2nd gear, high range, there is a knocking noise that I think has been there as long as I can remember. (This was my fathers first tractor); Lately it seems to have gotten louder and sometimes drops out of gear. Any thoughts...
  6. G

    distributor coil connection to cap

    tab on bottom of coil that makes contact with stud at top of cap that goes down to rotor, how does this work? Does power travel down this to the rotor? If so, where does it come from?
  7. G

    battery replacement

    I have a 9N, 6V, front distributor,3-brush generator with cut-out relay. Can I use a 8-V battery on this system and if I can will I need to make any changes? Thanks
  8. G

    resister on 9n

    what is the purpose of the resister between the starter switch and the distriutor on a Ford 9N and what should the ohm reading be?
  9. G

    head gasket replacement on 9N

    does it matter which side of gasket is "up" ? should the gasket be installed "dry" ? tightening torque ?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top