(800) 853-2651
SHOP NOW

Recent content by glenn kingery

Yesterday's Tractor Forums
  1. G

    3400 gas fuel ines

    Thanks for the photos. Looks like I would have had a problem. I had would have had the fuel pump lines reversed.
  2. G

    3400 gas fuel ines

    I did a tear down of a 3400 gas about 10 years ago finally finishing up restoration. But cannot find any diagram or photo of fuel line routing. I have to make the lines and don't know where each goes. Any help would be appreciated.
  3. G

    Crank endplay

    Rebuilding the 8n and found that there is too much endplay. I need to take up .008 to .01 of the endplay. Adjusting the play in the thrust bearing cap will not do it. Any answers would help.
  4. G

    8n steering shafts

    what is the difference between the early and late 8n steering shafts?
  5. G

    8N Long Pin

    It is available at external_link Years: 1948-52 Category I Top Link Pin, 3/4 Pin Diameter, 9-3/4 Useable Length, 10-5/16 Overall Length. Hinged Pin.( Used With 8N 4110 Bushing ) http://www.external_link/catalog/product_info.php?products_id=443 Untitled URL Link
  6. G

    steering shaft ball and nut

    I"m talking in reference to assembly of the steering shaft and the gear that rides on it.
  7. G

    steering shaft ball and nut

    I have disassembled the nut and balls from the steering shaft on my late model 8n. I seem to have a problem getting all 60 new balls into the nut for assembly. Is the a method to doing this?
  8. G

    8n rear axle

    Yes that is what I was talking about. Thanks!!
  9. G

    8n rear axle

    When I removed the rear axles you could see where they had been rubbing. I measured another axle I had and noticed that both out of this tractor were about 1/16 shorter. Is this a problem, should they be replaced? I don"t see any wear on the splines.
  10. G

    vc battery cover latch

    I looking for a latch for the battery cover on Case VC or a photo. I just received a cover but it was missing the latch. Maybe I can duplicate it with a photo.
  11. G

    case VC

    Yes I'm looking for the flip up cover at the back of the hood. And thank you for the electrical info.
  12. G

    case VC

    I have a Case VC that have been restoring for quite a while. have noe gotten to the electrical and cannot determine if it is to be a positive or negative ground. With the price of a regulator I don"t want to make a mistake.Any help would be appreciated. Also looking for the battery cover, it...
  13. G

    what is it?

    Not at this time. Could I get back with if I do? Once again Thank You
  14. G

    what is it?

    Thank You very much. This is a great help. I bought a manual for a Case VC last year but it doesn't cover very much. I also can't seem to find photos to help.
  15. G

    what is it?

    Would it be possible to get a photo of the speed limiter in the correct position or configuation?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top