(800) 853-2651
SHOP NOW

Recent content by gluther

Yesterday's Tractor Forums
  1. B

    Jerky, chattering hydraulics John Deere 1630

    I recently purchased a JD 1630 with 145 loader. Loader and 3 point hitch chatter when raising, but they have enough power to lift tractor. I have changed hydraulic fluid and filter, cleaned the sump screen and the screen on main pump, they were quite clean. I checked the valve above the filter...
  2. Geo-TH,In

    Battery Plus

    I stopped off at Battery Plus to drop off my junk Ni-cd and NiMh cordless batteries. While there I asked if they repair Li cordless batteries. NO! Why? Not sure but I suspect it has something to do with insurance.
  3. G

    8N Valve Guide seals

    That is my question. Im in the process of doing a valve job on 39 N and there are no seals on any of my valve guides but the new kit comes with 8 of them. How the Heck do you get those suckers in. With the seal on the guide it wont fit in even with a ton of lube and gentle persuasion. Whats...
  4. G

    9N Valve Kit Replacement

    question to all. Im doing a valve job on my 1939 N right now. I removed the old valves and the valve guides do not have a rubber seal on them. The new kit comes with a rubber seals. How critical are they? Are they needed? Why i ask is cause they are being a real bugger to get in with the seals...
  5. G

    1939 9N wont start

    yes i figured so on the compression numbers. either a valve job or a total rebuild is needed. Still stumped why she wont start thats why im leaning towards a timing issue. Cause even with bad compression she should run just not have any power. If valves are stuck maybe loosing combustion air...
  6. G

    1939 9N wont start

    Alright here is what i found. The first compression test came back as follows. cyl 4 =29lbs. 3 = 29 lbs. 2 = 29 lbs. 1 = 0 lbs. I put oil in each cylinder and let it sit for and hour then turned the engine over. I put more oil in each cylinder and waited a day. Oil came out of the carberator...
  7. G

    1939 9N wont start

    Thanks my 9N is still the 6 volt positive ground and yes I put in a new battery. She turns over like a champ. Most parts were really old when i bought her last year but she started every time till a few weeks ago. I had replaced the distributor cap cause it had a crack. I replaced the spark...
  8. G

    1939 9N wont start

    Thanks. I ordered a crank handle so i can turn the engine over with out wearing out the starter, plus have better control over the turning of the engine. Will check compression and rotor location to make sure it lines up with correct cylinder.
  9. G

    1939 9N wont start

    Thanks for the idea i will check that this weekend.
  10. G

    1939 9N wont start

    Help. Looking for thoughts, suggestions, ideas. Here is my situation. My tractor started everytime on the second try. first try with choke, then second without. after sitting for a week or so i tried to start it like usual. No go on the second try and now it just turns over without even a...
  11. G

    Parts for sale

    Would you happen to have a side cover. I have a 39 Ford 9N and the right side cover has a crack in it. Mine is the one with out the dipstick but I would accept one with the dipstick.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top