-
3 brush generator
This dont end...generator failed so installed new generator single pole + grnd. Now get 7.75 volts to cut out...when hooked up to resister..only 6 volt getting to battery...i must be doing sum wrong Or cut out went Bad Any advice ☺️ -
-
3 brush generator
Your correct..after i re hooked to battery charging 6.3 volts...thrird brush wont increase...but 6.3 im ok with.thank u kindley for assistance..im 80 yrs old..dont get under hood like in 60s 😂 -
3 brush generator
My problem is at cut out can..still 20 volts when i hook up to resister...it burns out condenser the cut out is New -
3 brush generator
I have a 1944 ford 2 n...3 brusg gener."the issue is putting out 20+ volts at single pole... There is no diff on 3rd brush adjustment..tractor post ground New cut out installed... Any advise how to fix -
3 point arm leaking fluid
Why can one Not seal it on outside with Jb weld just a thought- Gmk5150
- Post #6
- Forum: Ford 9N, 2N & 8N
-
Ford naa adjust issue
Got it..shimmed control rod..1/4 inch- Gmk5150
- Post #10
- Forum: Ford 9N, 2N & 8N
-
Ford naa unloader plug
No it's where unloader valve on foŕd naa just not sure how get plug out,wonder if help -
-
-
Ford naa unloader plug
I must be dumb...want change o ring on loader value not sure what plug needs to punched out.. small one i did try small one..wont move...thank all -
-
Ford naa adjust issue
Thank u kindly found part says no longer avai 8n539a...i keep seaching- Gmk5150
- Post #7
- Forum: Ford 9N, 2N & 8N
-
Ford naa adjust issue
Found issue the spring where u adjust draft control looks damage cant find part number or name of spring...anyone got part Number ford naa ty- Gmk5150
- Post #5
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy