(800) 853-2651
SHOP NOW

Recent content by Gochargers

Yesterday's Tractor Forums
  1. G

    Names for pulling tractors

    Precision Guess Work or Once Bitten Twice Shy
  2. G

    looking for advice

    I think I got it. Complete drain and rinse of the tank - dropped bowl off carb and cleaned - ran a copper wire thru main jet "ports" and reassembled. It ran 10 minutes til it ran out of the little bit of gas that was in the tank, so I refilled the tank. It ran 15 more minutes under a lite load...
  3. G

    looking for advice

    I'm always very careful not to get gasohol in my mowers or motorcycle. Some one told me it was hard on the rubber parts in the small motor carbs. Right or not - that's my protocol
  4. G

    looking for advice

    Nothing much worked today so I'll find a heated shop some where, I'll remove the tank and clean it and dry it. Hopefully the carb wont have to come off ----- but I'm not holding out much hope
  5. G

    looking for advice

    It's flippin cold out ---- I drained the tank. There is about an 1/8 inch of gas left in the bottom. As I rock the machine back and forth I can see tiny droplets that I suspect to be moisture. I poured a can of HEET in the empty tank and sloshed it around. I left the gas line disconnected to let...
  6. G

    looking for advice

    I ran a tank-ful of gas with HEET in it last summer, would that pull the water thru the carb??
  7. G

    looking for advice

    I have a snowblower with a 5 hp Tecumseh. It is 13 yrs old. The motor starts great. It was -5 this morning, I went to 1/2 throttle, full choke and gave it 3 primer pumps. It started on the first pull. I allowed it 5 minutes of warm up, and proceded to clean the drive way. I made 2 passes and...
  8. G

    gravity wagons

    Worked at a grain handling facility for ten yrs (89 to 99). The best unloading wagon for my money was the DEMCO. The worst were Kilbros and the old Dakons
  9. G

    combine motor

    It coulda been that he was gettin his chain yanked a little ------- sometimes tractor-pull opponents don't always show all of their cards.
  10. G

    combine motor

    He has a couple 77's and an 88. He lost last week to an M and a 77 with a combine motor --- now he wants one for himself
  11. G

    combine motor

    What model combine has an engine that will fit into a 77. Co-worker heard of this and says it will work well and give you around 90 hp
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top