(800) 853-2651
SHOP NOW

Recent content by GregA

Yesterday's Tractor Forums
  1. G

    Disk for JD B

    Looking to upgrade my 6' drag disk. Did JD (or anyone else) ever make a 6' Tandem Wheel Disk.
  2. G

    Tractor seat

    Does anyone know if Cory Anderson is still making seats.
  3. G

    John Deere M with M-2 plow

    I recently picked up a M2 plow. The front coulter and bracket is gone and the rear coulter is not original (looks to big). What is the diameter of the original coulters. Also the tail is broken off one share it's a Syracuse X1442F DDS-12 inch.
  4. G

    JD 60 Generator Problems

    I was hoping it it was just the contacts cleaning up. I have seen that arcing in the generator for a short time on my 630 after sitting through the winter. I want to thank you again for all of your help.
  5. G

    JD 60 Generator Problems

    Well John I bit the bullet and got a VR from JD as NAPA was almost as much $ and I would have to wait 4-5 days and with a chance of plowable snow this weekend I need the tractor. Cleaned up all the wire ends and generator case under the new VR before installing, polorized the generator prior to...
  6. G

    JD 60 Generator Problems

    It as a 4 terminal VR but I don't think it the original VR as the Load terminal is not used (there is a wire from the genterator side of the ampmeter to the switch). Yes the the ampmeter swings over to discharge when not running and you turn on the lights. For future reference does the generator...
  7. G

    JD 60 Generator Problems

    John T, I got back to my 60 last night and these are the steps I followed. Polorized the VR (not charging), ran a jumper cable from the battery to the generators case and placed a jumper wire from the VR ground strap to the jumper cable (not charging), removed jumper cable followed instructions...
  8. G

    JD 60 generator not charging

    John, I am going to try Teddy's suggestion grounding voltage regulater to generater first as that is quick. Then if I need to go to Para 5 how long is momentarily as I will have to jump it and get around to read the gauge, don't want to cause anymore damage. If I do need to install a new VR do I...
  9. G

    JD 60 generator not charging

    I took my generator and voltage regulator to a shop for a bench test, I don't know how long he had it on test but said it was putting out 14.2 volts. I ran a new 10ga wire from the voltage regulater to ampmeter and ampmeter to battery (new battery). I have hot battery voltage battery terminal on...
  10. G

    JD 60

    I would like to thank everyone for their suggestions/advise to my latest posts. I have the generator at a shop to get bench tested and repaired if needed. Although I have not yet opened the dash I plan to replace the wiring from the generator to the ampmeter and ampmeter to the battery (asuming...
  11. G

    JD 60 Running

    I did get my 60 running on Saturday but I am not sure what the problem was. My previous post was not accurate I had not changed points after the first incident, couldn't get points from JD to fit but after advise from this site I got a set from NAPA and put them in on Saturday. Change oil to a...
  12. G

    JD 60 Problems

    I did get the 60 running on Saturday, I really didn't do anything but change the plugs. It had power at the coil and fuel shut off appeared to be working. I still need to check remainder of wiring. I did have to change the battery (new JD Stong Box this fall) it showed full charge at 12.5 volts...
  13. G

    JD 60 Problems

    Yesterday my 60 started right up and ran like a top when warming it up to plow snow, pulled it 200' out of the shed and it shut down like someone turned off the switch and will not fire (white smoke out exhaust). This is the second time this is happened this winter and it's been a cold one here...
  14. G

    JD 60 points

    Can you tell me the part # for the Echlin points for a 60 JD and who would carry them.
  15. G

    JD 60 points

    Recently attempted to change the points on my 60, have tried 3 different sets of points from JD and none of them would slide all the way over the post on the distributor. Has anyone else had this problem.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top