(800) 853-2651
SHOP NOW

Recent content by gregy

Yesterday's Tractor Forums
  1. G

    12v conversion

    It was actually less expensive to convert to 12v then to buy a new 6v gen.
  2. G

    water in oil

    It's almost like a thin whipped cream, with air in it.
  3. G

    water in oil

    The lube oil in the trans, rearend of my utility 350 is grayish yellow. Where could the water be coming from. Radiator level is full, crank case oil is black. The yellowish color makes me think there is antifreeze in it. Is there anywhere where they share a common seal? Thanks.
  4. G

    12 volt coil conversion

    Front mount distributor. The 12v coil is 2.7 ohms. The extra resistor that came with the kit is 3.1 ohms. 14.5 divided by 5.8 ohms is 2.5 amps. Too low?
  5. G

    12 volt coil conversion

    It's a front distributor.
  6. G

    12 volt coil conversion

    I just installed a 12v system, the 12v coil measures 2.7 ohms. Do I need the extra resistor ?
  7. G

    6v to 12 v alternator mount

    I had the same trouble when I put my alt. on. I just removed the tube completely.
  8. G

    12v conversion

    Does it come in a kit and about what's the cost?
  9. G

    12v conversion

    I think you're right, the old one I took off must have been an off shore one and the rotor center tip and the carbon button must have ground the metal contact off.
  10. G

    12v conversion

    That's my theory too.
  11. G

    12v conversion

    Also the distributor shaft was tight.
  12. G

    12v conversion

    One thing the cap had no gasket under it. Another was one of the clips holding the cap on had been brazed and didn't hold the cap down tight enough on one side which might have caused it to break. Also the nut holding the points tight at the correct clearence was loose. Timing measurement was ok.
  13. G

    12v conversion

    I just finished the 12v conversion on my 8n. At first it didn't run very good, missed and back fired. Took off the distributor cap (front mount)and found the rotor contact had broken off. Ordered new one. Purrs like a kitten now.
  14. G

    Pertronix Electronic Ignition?

    Where in WA. are you located Dell? Greg , Moses Lake.
  15. G

    Getting neutered

    Where can you get fixed these days for $49.99 ?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top