(800) 853-2651
SHOP NOW

Recent content by greywolf224

Yesterday's Tractor Forums
  1. G

    Old Sherman 54B335 PTO pump.

    I have this old Sherman 54B335 PTO pump sitting on a shelf that was used on an old 54B backhoe that I have sitting out in the backwoods. Trying to figure out if I could repurpose the PTO pump to run an old 3pt log splitter. I’ve got some literature that tells me it runs at about 1200 PSI and I...
  2. G

    '49 9N not starting

    Following thread has a nice write up about a 9N starter switch and the mechanics around it. http://forums.yesterdaystractors.com/viewtopic.php?t=954029
  3. G

    '49 9N not starting

    BTW The above is for an 8N.
  4. G

    '49 9N not starting

    I take it you mean the rod at the bottom of this button. If so that Rod disables you from starting the tractor When the tranny is in gear. Needs to be in neutral. If you look at the side of that button there’s a small screw. A wire needs to be attached to that screw and back to you solenoid...
  5. G

    '49 9N not starting

    Do you mean a 39 9N or a 49 8N? Explain starter button is a rod not wires? Jumping a solenoid and it keeps running would lend me to think you are pretty much narrowed down to a dirty connection bad solenoid or whatever the rod thingy is.
  6. G

    8n2n9n

    From a far you can quickly look the rear rims. Different on an 8N provided its not a half breed.
  7. G

    Removing/Replacing Hood on 2N

    Some years ago I purchased one of those cheap harbor freight electric hoists that you attach on the beams of your barn or shed. I purchased the 400 single line or 800 double line pull model and attached it to the tractor shed way out back in the woods. I use a small 12 V inverter to power it...
  8. G

    45 2N 3 Point lift capacity

    I can’t speak for A 2N but my 8N lifts 800 pounds and doesn’t look back. I built an 800 pound ballast using ten 80 pound sacks of premixed concrete when using my front loader. Stupidly a few years ago I found a very large overhanging rock back in the woods and wanted to know that if I...
  9. G

    PTO Shaft Replacement

    HaHaHaHa :roll:
  10. G

    OT - In Memoriam, Dell (WA) 1938-2018

    The gates of heaven opened and called up another of the great ones. I am glad I was able to get to know Dell on this site if only for a short time. My condolences to you and your family.
  11. G

    Refurbishing '49 distributor - new rear bushing loose

    Now you are going to make me go buy some just so I can try. Thanks for the tip.
  12. G

    Refurbishing '49 distributor - new rear bushing loose

    Very difficult to type on these phones these days. What I wanted to write is that I don’t think that the retainer compound would help you any because your bushing is very loose.
  13. G

    Refurbishing '49 distributor - new rear bushing loose

    Can’t vouch for retainer compound. Never used it. But would think it would help you if you’re pushing is really is. The compound made glue it in but don’t know if it will keep it perfectly centered DOS illuminating any points gap or timing issues later on. I do remember my bushings setting...
  14. G

    Refurbishing '49 distributor - new rear bushing loose

    You actually get what you pay for or how fast of a delivery you’re willing to wait for. EBay is all about doing your research first. Know what you’re buying, look at the vendor that you’re buying from, compare prices and then make a decision. Obviously I wouldn’t buy bushings from a vendor...
  15. G

    8n advice

    My moneys on the head gasket And hopefully not a cracked head. In either case just pop her head off and have a looksee. If I remember correctly a few of the studs that hold the head down sit in the water jacket of the engine block. Remember taking mine out cleaning them up and putting...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top