(800) 853-2651
SHOP NOW

Recent content by grwrench

Yesterday's Tractor Forums
  1. G

    1010 model/ serial # plate

    hello,, take the old points to the store to get the correct ones,, 1010 & 2010,, had 4 different distributors,, 2 different Delco's,, Wico,, & Prestolite
  2. G

    2950 trans clutch slipping

    hello,, you need to try both hi & lo range on the hi-lo,, assuming you have that option,, if you are still slipping in both hi & lo,, then most likely the clutch in the flywheel is slipping.. you can perform that job without removing the cab.. however IF you are only slipping in hi only...
  3. G

    1010 model/ serial # plate

    hello,, you have a little more HP there,, as the original engine was 115 cubes, and this one has 145 cubes..
  4. G

    gasket permatex material

    hello,, the High Tac also drys out ,, I threw away a can of it this week because it was dried out,, less than a year old,, the Permatex avaition gasket sealer,, shellac lasts longer than that,, I use it on ALL paper type gaskets for water, antifreeze applications,, for 50+...
  5. G

    gasket permatex material

    hello,, DEERE friends,, what do you use to thin out Permatex aviation gasket dressing that has gotten thick???
  6. G

    Any thoughts on a John Deere 6300?

    hello,, look closely at the hydraulic oil and the filler neck on the rear above the PTO.. IF you see ANY signs of moisture, water droplets,, milky oil,, turn around and RUN , these are good tractors IF the above signs of water are NOT present.. if the tractor sits out in the rain...
  7. G

    Oliver 1750 tractor

    THANKS,, Oliver friends,, I am a JD tech. sooo,, do not know much about this tractor,, this belongs to a friend,, soo,, do not know if he has a OP. manual..
  8. G

    Oliver 1750 tractor

    hello,, Oliver kid,, I am back again,, this tractor is hydra power, not hydra shift,, sooo,, is this different from the info I got for the hydra shift?? I looked briefly at it today,, the oil filter that rusted thru is above the LH brake assy.. I see a breather cap on top of the rock...
  9. G

    JD 1530 Gear Shift/Cover Replacement

    hello,, looking at your picture, the old cover has a plug in place of the hi lo valve, you have to remove that pin// plug and install it in place of the hi lo valve. this pin has a small spring pin driven thru it, 34H231,, 3/32 X 3/4 size,, with the hi lo valve in place without the...
  10. G

    JD 5210

    hello,, after you service the screen & change the filter,, check the hose clamps on the suction pipe from the pump back to the filter,, the hoses on the end of the steel pipe age and get hard and clamps need to be tightened,, because these conditions cause the pump to suck air making...
  11. G

    Oliver 1750 tractor

    hello,, the oil gushed out about a month ago and I did not stick my finger in it on the ground,, I was surprised to learn that 90W oil can be pumped thru a spin on filter,, I will check all this out soon, as the tractor is 30 minutes away from me.. Thanks again for the info..
  12. G

    Oliver 1750 tractor

    Thanks for your reply,, soo,, this spin on filter is filtering 90 W gear oil?? when the tractor was running the oil gushed out from being Pumped ,, soo,, i figured some other oil than 90 W gear oil???
  13. G

    Oliver 1750 tractor

    a friend has a Oliver 1750 hydra shift tractor,, I am a J Deere tech,, soo, am not that familiar with Oliver,, here is my questions?? under the LH floor plate is a spin on oil filter,, this filter rusted thru and spilled oil out,, what kind of oil goes here?? where do you check it...
  14. G

    3010 trans issue

    hello,, I just looked up the detent for the 3010,, and it is the same part # for the 3010,4010,, all the 20 series,, all the 30 series,, WATERLOO,, the 40 series up grade to the ball & cup,, I have changed a number of the 20 & 30 series detents to the ball & cup in the last 50...
  15. G

    3010 trans issue

    hello,, just the detent,, you may need R59378 spring..
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top