(800) 853-2651
SHOP NOW

Recent content by handcrank

Yesterday's Tractor Forums
  1. H

    Wd starter

    Havent been able to get it to engage on the bench so far.could it be inside the starter? Im87 years old and this is all new to me.thanks to all of you for your input.
  2. H

    Wd starter

    Is there anyway to check the starter while on the bench? I have a new switch ordered.
  3. H

    Wd starter

    I have an old wd and when I tried to start it this morning itwont do a thing.all connections are tight.could it be the starter switch? Thanks
  4. H

    Wd govener

    When you say that the govenor exploded does that the magnets will be in pieces?
  5. H

    Wd govener

    Thats exactly what it does when I try to give it some throttle.are the magnets something that I can replace and where could I get them?
  6. H

    Wd govener

    Should there be a spring attached to the carberator to control the govener?my wd wants to run wild.its a 1949.thank you.7
  7. H

    F12 running again

    I agree with you. This is the second time I've had to replace the diaphragm since I've owned this tractor. I do think setting idle for so long had a lot to do with it. (DRYING OUT).DON.
  8. H

    F12 running again

    I finally got the repair kit for the fuel pump and she's running again. The diaphragm had a tiny hole in it. It's good to hear it run again, after resting in the barn for ten years.
  9. H

    F12 woes

    After getting my f12 started, it ran for a while and died. I cranked it for quite a while with the choke on then removed the plug in the bottom of the carb.Im getting no gas to the carb. I went over the fuel pump before and I thought it was okay. After setting for so long (ten...
  10. H

    F12 runs again

    After resting in my pole barn for 10 years, my 1938 f12 came to life today. I,ve been going over everything these last few weeks, whenever I had time. I went through the fuel pump, carb, magnito, made sure the tractor was timed to the mag,carb setting according to the book. After I...
  11. H

    F12 carburetor settings

    What is the carburetor settings on the f12 to get it started?
  12. H

    F12 numbers

    I went through the carburetor and everything was clean and the float is good. The fuel pump seems to be in good shape. Not sure what the settings are on the carb.All I have to do now is start cranking, to see if the bowl fills with gas.I will let you know how it goes. ALL OF YOU GUYS HAVE BEEN...
  13. H

    F12 numbers

    How many f12 tractors were made and why were the f14s only made for a short time?I have a 1938 f12, I'm trying to get running after 8 year rest. I love these old tractors.
  14. H

    F12 fuel pump

    I don't know what you mean when you say it should hold vacuum with the bowl on it. I have the tractor timed on tdc on number one cyl.would the push rod be retracted all the way at this time?if it is I should feel a little resistance when I install it. Correct? Bear with me, this is all new to...
  15. H

    F12 fuel pump

    Is there a way to check the fuel pump for proper operation when it's on the bench?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top