(800) 853-2651
SHOP NOW

Recent content by Hap420

Yesterday's Tractor Forums
  1. H

    3010

    To the best of my knowledge the industrial equivalent of a an agricultural 3010 was just still labeled as a 3010. I know a gentleman with an industrial 3010 backhoe and it is labeled as such. As far as I know the change to the 20 series agricultural series is when the change to the hundred...
  2. H

    ol1650 adustable steering wheel

    I had the same problem. Check to make sure that the nut that holds the aluminum spinner to the steering shaft is tight
  3. H

    Tractor Tire Tubes (What brand and where at?)

    6.00x16 is pretty common around here. Tractor Supply has them and I haven't gotten a bad one yet
  4. H

    1650 hydra-power

    Hey guys, hydra-power on my '69 1650 hesitates when shifting into hydra-power drive, sometimes only a little bit but sometimes it almost comes to complete stop and then clunks in. The manual says it could be a weak retractor spring but then I can't find any other mention of such a spring in...
  5. H

    1650 hydraulic oil change

    Hey guys, I have a 1969 Oliver 1650. I"m trying to change the hydraulic oil. According to the book there should be a plug on the left side near the top of the unit under the seat. I don"t have that plug. Whats the next best place, at the rear outlets or maybe the lines along the left side going...
  6. H

    ford 2110

    hey guys, quick question, will a 770B loader from a 1710 fit a 2110? thanks
    • Hap420
    • Thread
    • Replies: 1
    • Forum: Ford
  7. H

    Super series 3 point

    Ok, thats what i thought. Well I got a good deal on a pretty much junk 770 with power traction hitch, and was hoping to put in on my super 88. Any suggestions? Thanks again
  8. H

    Super series 3 point

    Was the power traction hitch ever available for the super series or not until the three digits? Also was there any sort of three point hitch available? Thanks guys
  9. H

    super 55 diesel timing

    Hello all. I have a 1955 super 55 diesel that I just did a major overhaul on. While I was at it I purchased all the components I needed to change over to the roosa master pump like on the late 550s. Now if I pull start the machine about 20 feet or so it will fire and run great. Problem is I...
  10. H

    3 bottom semi mount

    hey all, I am looking to buy a 3 bottom semi mount plow. It could be deere, oliver, case, ih, not fussy about that, just want it to be in good condition. i'm in new england but willing to travel a little, anyone who has one or knows of one please let me know thanks
  11. H

    Help with 550 power steering

    How much have you lost? It is probably seeping down into the steering box, it can not get into the transmission
  12. H

    Pretty Proud of this little find Also (Pic)

    I have a five disc on rubber with hydraulic lift. had the same problem not pulling well, adjusting the tail wheel helped a lot and my manual also says to pull with a swinging draw bar. nice find, wish a had the scrapers on mine
  13. H

    OC-6 diesel issues

    the pop comes from the exhaust and then the smoke clears right up. i have had the hydraulic pump rebuilt and the brake bands are adjusted properly. its almost as if one cylinder stops firing and then a few seconds later kicks in again. it only happens when it has a good load on the engine, like...
  14. H

    OC-6 diesel issues

    I"ve got an OC-6 diesel that has a bit of a problem when warmed up. It starts right up and runs great, but i"ve been harrowing with it and after running it for about a half hour under a pretty good load it will bog down and start blowing black smoke. After a few seconds it will kinda pop...
  15. H

    OC-6 question

    Hey all, I have a an OC-6-68 diesel that I can not seem to get to travel in a straight line. I have a manual and can't find anything in there about keeping it straight. I want to be able to pull a one way disk tiller with it but it wont stay straight and I know it's not the plow because my John...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top