(800) 853-2651
SHOP NOW

Recent content by henry v11

Yesterday's Tractor Forums
  1. H

    W9 fuel pump

    Did the W9 run better with the fuel pump. I disconnected mine years ago when I was using the tractor a lot and did not seem to notice any difference in power just wondered if I made a mistake
  2. H

    W9

    Iam still trying to find the correct # Champion spark pluf for my 1948 W9. ANy one have any ideas. Thank you
  3. H

    10-20 decals

    Mr PGO thank you for the information. I have had this tractor since 1963 and sure want to get it back the right way. Looks better now than it did in 63 but she worked harder than. thanks again Henry
  4. H

    10-20 decals

    We got our 10-20 all painted and ready to go, We have a set of new decals but are not sure where they go on the tractor. could any one help us with this. Tnanks Henry
  5. H

    10-20 MCcormick deering

    Parts: Try Ford barn. SN: Sould be under the gas tank on the support frame facing the engine.
  6. H

    10-20

    How much gear oil and what wieght should be used in the 10-20. When we sand blated the tractor prior to painting some sand got in the housing via the belt pulley attachment. We would like to drain all the oil out and than flush with diesel fuel and refill, Thanks
  7. H

    W4 charging

    Well I got our W4 to charge ok now with the 12v gen. I called Stiener tractor with the SN of the Gen and they told me what VR to get. I went to the local Auto Zone and got it for $23.00 and all is working fine now. Iam still using the Old 4 postion light sw and amp meter just ran the F wire to...
  8. H

    W9 clutch

    I changed the one in my W9 that way several years ago the ITC book helped me a lot. Believe me if I can do it anyone can.
  9. H

    W4 Gen

    First of all I want to thank you all for all the help you have given me. Here is what I have. I Have mag ign and no lights inatalled with a 12V battery. I inatalled a 12V gen it charges 12-15 amps. However it is hooked up with the old 4 pos BDHL switch. There is a 3 pos VR with only the first 2...
  10. H

    12V on W4

    I have a W4 with a Mag ign. If I use Bob M wiring diagram for conv to 12V what do I do with the ign sw as mine is for grounding the mag. What type of alt is best to use. Thank you.
  11. H

    I4vsW4

    Thanks to all who replied to my question. It was all very helpful. Henry
  12. H

    I4vsW4

    Could someone please explain the difference between a I 4 and a W 4. I think the I 4 is geared different but that is all I know. Thank you.
  13. H

    w4 gen-reg

    We bought a 1949 W4 at a auction on SUnday. It has a mag and no lights.It has a 12V battery. It has the 4 pos light sw. There is a VR with 2 term. 1 being the 12V(B) and a smaller wire going to the Gen. The Gen has 2 term.I wonder if they just installed a 12V batt and left the 6V gen and reg in...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top