(800) 853-2651
SHOP NOW

Recent content by Hepcat66

Yesterday's Tractor Forums
  1. H

    Parts for sale

    From the lift cover assembly on an 8N, do you have a drawbar control arm? The part which has a pin that rides against the large eccentric on the lift ram arm? Thanks, Don
  2. H

    8N wheel center doesn't it my new rims!

    Sounds like hd6gtom has the right answer. I didn't have the nerve or the equipment to do it the right way so I trimmed a very small notch off the centers. The new rims are fromTISCO and are U.S. made. They do have the ramps too. Having the tires swapped tomorrow at Ag West. Nice that they're...
  3. H

    8N wheel center doesn't it my new rims!

    It was actually the wheel center I was thinking of modifying. Thanks.
  4. H

    8N wheel center doesn't it my new rims!

    Got my new rims today (from YT) but the wheel centers are a little to large in diameter to fit against the face of the lugs. I assume this is a common problem. It's pretty close, needs .050 or .100 removed where it fits against the rim lug. OK to relieve that area?
  5. H

    Socket size

    Regarding the rear axle nut locking wire, are there several holes for the locking wire so it can be adjusted? Thanks, Don
  6. H

    Liquid in tires

    One of my 8n's rear rims partially split today due to the extreme rust in the past. I'm in the process of draining the fluid. It's blue in color and smells lightly of antifreeze-definitely not salty. About how many gallons would be in a 13.6-28/12-28? Thanks. Don
  7. H

    8N Front hydraulic pump shaft

    I had a similar problem when removing the 702 loader from my 8N a couple of months ago. The front pto was a mass of rust so I had to cut the shaft with a 7" cutoff wheel in the angle grinder. At that point I was in the same situation as you are. I ended up removing the hood and radiator, and...
  8. H

    8n hood/radiator problem

    This message is a reply to an archived post by michaelthorne75 on December 25, 2017 at 12:42:51. The original subject was "8n hoodradiator problem". About those lower radiator pads which I need to install with my new radiator: How tight should those carriage bolts at the bottom of the radiator...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top