(800) 853-2651
SHOP NOW

Recent content by Homerville Bill

Yesterday's Tractor Forums
  1. H

    leaking utf from brake drum

    I think you hit the nail on the head. I have over filled. I hate to ask this but where is the fill for the hydraulics?
  2. H

    leaking utf from brake drum

    Finally got my 860 running. Thanks to many of you. Topped off the rear end fluids and noticed some is dripping out of the rear break drum. I am assuming there is a bad oil seal.can anyone confirm that is likely the issue? Thanks.
  3. H

    cylinder number

    Did something stupid on my 800 series. I did not Mark what cylinders each piston came out of and need to know if the 1 is at the front or back. And just to make sure the rest of the order. Thanks in advance.
  4. H

    Rocker arm/pushrod/valve adjustment

    OK. So just to make sure.. at the bottom of the stroke, both valves should be closed?
  5. H

    Rocker arm/pushrod/valve adjustment

    I had the head worked on my ford 800. While it was being worked, I decided to take the rocker assemby apart and clean it. Including the adjustment above the pushrods. That was a waste of time. But now I have no idea how to get the rocker in the right position. I am wondering if I put the piston...
  6. H

    Ford 800 Head

    I am going to take the head in and have it looked at. Now about the crank shaft.I am going to look at the bearing. If they are not work should I have the crank looked at?
  7. H

    Ford 800 Head

    Sorry for the crappy reply earlier. I was not aware of all the things that must be checked to make sure the work goes as planned. Now after talking to some mechanics (should have used one)I understand why if you going to part of the job you might as well do it fully and right. Sorry!
  8. H

    Ford 800 Head

    Near amazement??? I thought I had a cracked piston in one cylinder since under stress oil would spray of of the breather. It seemed that the oil pan was getting pressured, and that one spark plug was all cruddy. Not only that but the oil smelled like gas, and when the tractor was running there...
  9. H

    Ford 800 Head

    I decided to replace the rings on my Ford 800. I have never done this type of job before. Do I have to have the head machined before reinstalling?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top