Recent content by hoss54

  1. A

    AC 303 baler

    Getting ready for hay, and the last time I used our Allis 303 bale chief, we were having trouble with it not wanting to knot on one side. Up till now it has been a fairly good baler. I've check my owners manual, and I believe some parts need to be replaced. I do not know if it is correct, but...
  2. K

    T030 stalling

    I have a 54 T030 that is having intermittent problems. It acts like it is starving for fuel or running out of gas. I have to full choke it to keep it running. It usually does this after warm but it actually acted this way once right after a cold start. Then, it seems to straighten out and...
  3. L

    dumpster diving?

    Whenever I pass by this one deli I check for empty buckets,I have asked the owner in the past ,he is glad someone can use them,Over the years I have gotten many there,got these today.Not a big dumpster score,but a handy one?
  4. H

    MASSEY 85 PARTS ON OHIO OR PENN?

    I wasn't sure if these links would post, so as you could just click on them, and go to the site... And they didn't.. You will need to copy, and paste them. If you're not sure how to copy and paste... Put your cursor (pointer) on the link address, at the same time hold down on the left button...
  5. H

    MASSEY 85 PARTS ON OHIO OR PENN?

    Here is a link to TractorHouse, and listing of 85's for parts. Many in Ohio listed. http://www.external_link/listings/parts/search.asp?Manu=MASSEY-FERGUSON&Model=85&MdlX=Exact&PartNum=&grp=&dlr=&CID=&guid=D9EA9E0C0C8C4072BDC7F776F30F062C Or a link from TractorHouse searching for that...
  6. H

    Case 210B Gas Tank needed

    Do you, or anyone know if this is the same tank used on a 310B..?? Some folks on ebay I bought some parts from had one, but no one bid on it. I can send them an email inquiring about it, if it will fit... I'm thinking the starting bid was like $29.99.
  7. H

    Case 300 or 300B

    I've gotten myself spoiled with little amenitie's like that. Wouldn't be without one now.. Sure makes cleanup a breeze!! Guess the secret is to having a low CFM angle grinder, to save running the compressor much. But they are sweet.. And you can find some deals on pads on Epay, if you keep an...
  8. H

    Case 300 or 300B

    These are just the roloc pads you use to clean off gasket surfaces... Just kept it moving, and it seemed to do a real nice job.. Yep, I've done the sandpaper thing numerous times on our IH's...
  9. H

    Case 300 or 300B

    I hope I did this right... Here is a picture of the brakes on the 300 Series. This picture is from the Case/IH online parts book. The brake housings are located behind where your feet rest on the floor boards/foot rests. There are 4, 5/8" studs holding the housing to the differential case...
  10. H

    Mysterious clunking noise in my 165

    May try checking you pump support pins. These are located about 5 o'clock from the differential side cover on the right side, 7 o'clock on the left. You should see two 3/8" nuts holding a litle plate on. Shows a good picture of them on page 374 (differential housing and PTO shaft) of the 165...
  11. H

    630 PTO shaft

    Here is a link to TractorHouse. http://www.external_link/listings/parts/Search.asp?guid=BB3674CFF9E8479AAF95C6707414C4DE I did a parts search by model number, and there were 7 at various salvage dealers in the U.S. They are only a phone call away... You have to scroll down, and search...
  12. H

    6 incoming...hit the dirt

    Gee..., haven't seen an on land hitch since the 70's, when my buddy had one behind his ole' IH 4100.
  13. H

    SC Brakes

    If, and when you decide to replace those seals, here is a link to a place where I buy a lot of my bearings and seals, and this link will take you to the seal you need... http://www.jbr17llc.com/skf-37390.html I ran that part # at NAPA online... Almost $40.00 ea. It takes about a week to get...
  14. H

    Brake Shaft Seal Saver...

    You're surely welcome...
  15. H

    Brake Shaft Seal Saver...

    In another thread yesterday, there was a discussion on replacing brakes, and seals on a 530. I jumped in and gave my two cents worth, as I'm repalcing the one's on my 310B at this time. Not realizing that the 530 had both disc, and band type brakes. None the less, both, and many others..., have...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top