(800) 853-2651
SHOP NOW

Recent content by HWS1020

Yesterday's Tractor Forums
  1. H

    Electrical system upgrades.

    After some searching I finally found my original info. Then I realized I had some brain fade during my original conversation yesterday(being in the hospital and on pain meds probably didn't help. lol). What I had actually come across were 6 volt alternators configured to look like old long and...
  2. H

    Electrical system upgrades.

    Hi Everyone, I have a couple of older tractors. Most of the time I have no issue with generators. But there can be times when they are problematic. And it seems like a lot of alternators require sheet metal modifications to be properly fit. Recently while scouring around online I came across an...
  3. H

    A-C D-17 3 pt hitch suggestions.

    I have contemplated building my own hitch but right now I'm kind of strapped for the time to do that. So right now if I can just install one would be more feasible. Thanks for the input.
  4. H

    A-C D-17 3 pt hitch suggestions.

    Hi Everyone, I have a Series 2 D-17 with Snap-Coupler hitch. I have a plow and harrow attachment but that's it, so far. I already have a few other pieces of 3 point equipment I'd like to use with it. I am considering purchasing a 3 pt hitch conversion for it. I have noticed there are a couple...
  5. H

    International sickle bar mower ID.

    Hi everyone, I have a IH pull type sickle bar mower. I'd like to find a manual for it but I'm not sure what model it is. If someone could ID it for me I would greatly appreciate it. Any other information anyone may have would also be of interest. Let me say thanks now. Best regards, Howard
  6. H

    Allis Chalmers plow and cultivator ID.

    I haven't had a chance to look the plow over to find and record any part numbers. I did order a manual. I hope to see that shortly. I located a parts manual and I'm thinking of ordering it. I thought the shins were a little unusual. Paging through some eBay listing I may have figured out the...
  7. H

    Allis Chalmers plow and cultivator ID.

    Hi Everyone, I am new to Allis tractors and equipment. After purchasing a D-17 still with it's Snap Coupler hitch I have located a Snap Coupler plow. It is a 3 bottom, 14". I'm pretty sure it's a good combination for the tractor and my needs. I'm just not sure how to tell what model or series...
  8. H

    What to look for on an Oliver 1800

    Yes. I'm sorry I haven't had a chance to reply. I'm on my pad I'll email shortly. Howard
  9. H

    What to look for on an Oliver 1800

    I have the option of trading my JD 1020 with a loader for an Oliver 1800. I had the serial number but can't locate it. I believe it's an "A" series. It is a diesel. I've been thinking of up sizing so I'm a bit interested in this tractor. I have no previous experience with Oliver and was...
  10. H

    JD 1010 trany parts. Help needed.

    Just to let anyone who reads this to know, I did locate parts for my 1010 trany. A gentleman at Goodrich Auctions located them for me. His prices weren't out of line either. I found a few places on line that indicated that they had the parts but calling proved they didn't have all of them or...
  11. H

    JD 1010 trany parts. Help needed.

    Hi everyone. I am in the process of rebuilding the transmission on my 1010 wheel tractor. It blew the rollers out of both bearings on the input shaft. It obviously ran with water in it as well for a while. The shaft isn't buggered up from the bad end bearings but it is where the needle bearings...
  12. H

    Case 530 CK backhoe engine.

    Hi John, You mentioned being across the lake from me. Do you have anything I may be interested in or the where about's of? Any leads would be appreciated. Howard
  13. H

    Case 530 CK backhoe engine.

    Hi Ttim, How can I best contact you to discuss your engine. Howard
  14. H

    Going to look at TD-6 International

    Hi. I Found a TD-6 dozer near me for sale. I'm going to look at it tomorrow (Sat 9/5). It runs and operates. Is there anything I need to pay extra attention to while looking it over? Are there any special techniques for checking if there is a problem with a certain component? Any tips would be...
  15. H

    Gleaner models.

    Hi. Thanks for the replys. I know more now then I did. lol. The Gleaner site looks like a good reference to keep in mind. I'll be book marking that site. Thanks again for the info. Howard
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top