-
J
bush hog setup on a TO-20
This message is a reply to an archived post by Bob Kerr on August 30, 2007 at 20:04:55. The original subject was "Re: bush hog setup on a TO20". I have a TO-30 with a 5" mower on the PTO, the shaft is triangular but the tube and the two plastic safety covers are shot. DOES ANYONE know where to...- jagman55
- Thread
- Replies: 3
- Forum: Harry Ferguson
-
J
Ferguson Matching Temperature gauge
I have a Harry Ferguson 1952 TO 30 which has no temp gauge so can anyone tell me if one can be 'adapted" to the Radiator or block? If so, can you suggest who might have the 'kit'? Thanks- jagman55
- Post #1
- Forum: Harry Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy