Recent content by Jay Liedman

  1. J

    Suggested Oil for a U302

    I just acquired a U302 gas, and am wondering what the recommended engine oil is?
  2. J

    Tractor Radios

    I probably get there about annually. You can email me an address at [email protected]
  3. J

    Tractor Radios

    I am in central Minnesota.
  4. J

    Tractor Radios

    I recently acquired a U302 Moline that has a nice looking radio mounted on the fender. It LOOKS like it is in good condition, but does not work. I know from past experience the vibration from the tractor is hard on things like radios, but do not know just what actually breaks in them. I would...
  5. J

    Disk ID Help Needed

    I just picked up a 13 foot Oliver Disk. The Model label is off, and I would like to figure out the model to facilitate finding parts such as seals and bearings. I have attached some picture, and would appreciate any opinions on the model number.
  6. J

    Athens Disc plow ID

    I picked up what I think is kind of an interesting piece at the LeSueur Swap Meet this past Spring. It is a 3 bottom Athens disc plow. I do not know much about it, and would like to get some information such as what model it is. Also, there are evidently a couple pieces missing on the...
  7. J

    Old 15W-40 oil

    I have a 5 gallon can of 15W-40 diesel oil that has been in my shop for a long time--perhaps 20 years. I was pouring some out tonight to top off the oil in my IH 1206, and noticed there were some globs of stuff about the consistency of snot in it. Has anyone encountered this before? If I ran...
  8. J

    Farmall M hydraulic problem

    It is a ONE hose setup. I did finally get it to work. I unhooked the control rod, then pushed the lever further to see if that would make a difference.. When the lever was pointed all the way to the ground, it allowed the planter to drop. I ended up taking the lever off, then reattaching it...
  9. J

    Farmall M hydraulic problem

    Original Lift-all, as far as I can tell. It is operated by the pull lever on the right side of the tractor. The rest knob on the pull lever is what keeps the unit raised.
  10. J

    Farmall M hydraulic problem

    I tried using the hydraulics on my M to lift up my corn planter, and have run into a problem. It lifts just fine, but even if you depress the lever all the way it will not let the machine go down. I do not know much about hydraulic systems. I assume it is a malfunctioning valve somewhere...
  11. J

    VAC Case sparkplug cover

    I'm looking for the spark plug shield/cover that came on the VAC Case. It appears most farmers took them off when they changed a pug, and never put it back on. I've been searching parts flea markets for a while, but have not seen any. Anyone know of a source?
  12. J

    OMC 595 Round Baler

    Do you have the cast iron cam that the bar rollers ride in, for the OMC 595?
  13. J

    ZTU Brake Drum Removal

    I finally got it off. I do appreciate all the suggestions. I heated and pounded and pried a number of times; not much movement. I eventually took a wrecking bar and pried pretty hard. It did not come off, but I braced the wrecking bar against a long bolt I screwed into one of the holes on...
  14. J

    ZTU Brake Drum Removal

    I am trying to restore a ZTU, and the right brake is frozen so the right rear tire cannot turn. I have been trying to get the drum off without success. Have heated it and pounded and pried on it. Anyone have any advice, or know of any trick or tool to get it off?
  15. J

    IH 715 Combine engine issue

    Radiator fluid temp remains around normal range.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top