Recent content by Jeff 170

  1. J

    1175 mets 2670

    Thanks for the reply I just thought the oil sump needed to be changed for a cast pan to work.
  2. J

    1175 mets 2670

    I just went on U Tube and watched a ton of case pulls. I saw a lot of steel pan tractors running very hard without rails. Only a couple ran homemade rails.
  3. J

    1175 mets 2670

    I guess what I would like to know if frame rails are needed ? It is going to be used for pulling.
  4. J

    1175 mets 2670

    I saw the 930 with the 2670 engine. I am doing the same swap to a 1175. I was wondering about frame rails if I run the steel oil pan. It would be nice not to and not run a cast pan if I can. Is there a factory frame rail I could use that would bolt on if you think they are needed. I will post...
  5. J

    170 allis cab

    Thanks for the information.
  6. J

    170 allis cab

    Will a 200 Allis Year Around cab fit on my 170 open station ? Also i have a loose steering sector. Does anyone have a repair for this ? A new one is $730 dollars ! Its loose on the gear not tie rods.
  7. J

    Allis 170 Steering

    My local area Massey dealer told me it was $718.05. After my heart attack, i tried one more dealer but it was the same price. Does this part get loose or am i unlucky? The tractor has 5400hrs and a loader. Does anybody have a alternate fix for this arm?
  8. J

    Allis 170 Steering

    Yes, it is the part. I tried to go on their site but it wouldn't let me in. Thanks for the info. I will try the AGCO site again.
  9. J

    Allis 170 Steering

    I"m looking for the steering arm the tie rods connect to on the steering shaft. Is it available OEM or aftermarket? Does anyone Know the part # from AGCO? It is on a 170. Can any AGCO dealer get parts for an Allis?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top