(800) 853-2651
SHOP NOW

Recent content by Jeff in Oh

Yesterday's Tractor Forums
  1. J

    OT Far Arms

    I also carry, always, if your going to do it, DO IT. The one time you don't might be the time you needed to.I've been carrying for 3 years, legally, since they "gave" us the right here in OH.Hope I never have to use it, but I'm prepared. I use a Kahr Arms .45, usually on me, always in my...
  2. J

    fresh rebuild wont start

    Thanks again guys. I did manage to get it to start a couple of times for just a couple of seconds so hopefully all ignition is good. I did however mess my starter drive up with all the turning over. So I guess it will be a couple of days before I get that fixed. maybe I'll try the pull start...
  3. J

    fresh rebuild wont start

    I know I can pull start it but then I'd have to finnish putting the front end on and the hood and then I'm still waiting to find a used front rim and another rear tire, hopefully both are coming soon.It seems to turn over real good with the starter,I'm just getting excited to hear it run. Thanks...
  4. J

    fresh rebuild wont start

    Thanks dan, I did most of that except the wide open throttle.I had it set about half, didn't want to over rev a fresh engine.I'll just have to watch it if it does start. Jeff.
  5. J

    fresh rebuild wont start

    I'm looking for a place to check at this point. My 9n front dist. has a fresh overhaul and I cant get it to start. Seems to be sparking ok and from what I can tell the distributor is on correctly,#1 cyl. pushed my finger and rotor is coming to #1 position. I did line the dots up on the gears...
  6. J

    valve spring direction

    Thanks Bob ,I'm heading back out to the shop now and hopefully all will go well. Jeff.
  7. J

    valve spring direction

    I havn't been following everybodys posts for almost a year.and I miss that. Been busy working and farming and fixing everything around here.I'm finally getting around to putting my 9's engine back together and I've come to the valve springs. The new springs(as well as the old ones) have a...
  8. J

    old hay wagon

    Thanks for the info guys. It is not a car axle, it has no lugs at all, just a hub with grease fittings in and out. It has what appears to be a grease cap with a square nut shape on the end. The axle appears to taper down and go into the rear of the hub.
  9. J

    old hay wagon

    I bought an old hay wagon the other day. It has a wooden running gear, axles and all,steel spoked wire wheels with rubber tires.It's in pretty good shape,the guy we got it off of said he used it as a backup wagon and had 100 bales on it with no problem.My question is what is involved in...
  10. J

    main bearings

    Thanks for all the advice. I guess I'll have to take it to machine shop and have it line bored.The guy said they were the caps that came with it , but who knows.
  11. J

    main bearings

    OK I'm back. The front cap says 9n6607( I think 07,stamped really faint). The middle cap, CS, and the front cap 6 CS.
  12. J

    main bearings

    Thanks for the quick reply Dunk , I'll run out to the shop and check .I'll be back In a couple of minutes
  13. J

    main bearings

    Does anybody know if the main journals are all the same on 9s 2s and 8s? I bought a used block to replace my badly cracked one in my 9. My crank is in very good shape and had .10 bearings so I purchased new .10 ( they mic the same as the old ones).I put the crank in today and can't even snug...
  14. J

    Quick couplers for JD 50?

    I've got a 60 and all we did was leave the plugs in, and on the right side of the PT unit there are a couple of pipe plugs, get some iron pipe nipples and a couple of elbows of the appropriate size and length and run it out the back with your new quickconnects on the ends. We've used it with a...
  15. J

    9N bipass valve?

    Thanks Jon ,You just made another discision for me.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top