(800) 853-2651
SHOP NOW

Recent content by Jeff Meehl

Yesterday's Tractor Forums
  1. K

    64 international cub misses after 10 min

    Please help. Got a 64 cub that misses after it warms up. Changed points ,condenser,rotor,cap,wires,coil and plugs. Checked the compression when cold and warm. It dropped on average 10psi. All over 110psi. Cleaned carb. Runs fine with no miss when cold. Started when the coil went...
  2. D

    Hey Loren

    Just read yesterdays post. We gathered 900 gallons of sap yesterday. Froze last night and the trees are just starting drip now this morning. Depending on whose forecast you care to believe, we will get no frosts this coming week or possible frost Tuesday and Wednesday night. No frost will...
  3. A

    Tractor Pull and Antique Show

    Blue River Valley Antique Power Association in Shelbyville, In. is having an annual show on June 7th and 8th, 2013. Tractor pull on June 8th at 3;00 pm. Please contact Dan Brown @ 812.344.0205 or Paul Nieman 317.512.3951 if you have any questions.
  4. J

    Allis Chalmers G and Implements

    Got one looking for another also. What are the details and which implements have you? Jeff
  5. R

    Way OT. canadian drugs

    Anyone know of a good dependable source for canadian perscription drugs?I see a lot of places advertising.My cholesterol medicine is 287 bucks for 30 pills.My wifes medicine for copd is 240 bucks for 30 days.My insurance is 1500 per month and doesn't cover anything till my 5800 deductable is met.
  6. A

    moline U engine question

    I have just bought a moline U. I am wanting to put in the six inch crank but keep the stock U blocks. Is anyone making pistons for this combination? Can I use the stock rods? Is there anything else I will need to do?
  7. H

    SHAW DU-ALL N5

    This message is a reply to an archived post by chris misischia on August 05, 2008 at 18:08:37. The original subject was "SHAW DUALL N5". http://shaw.10.forumer.com/ new forum just for shaw products
  8. J

    Sunshine, digging snow and three legged deer photos

    Dug a road through my fields yesderday with a bulldozer and crawler-loader. We've had temps a little over freezing for three days and snow is now down to 2-3 feet deep. Supposed to hit almost 40 F degrees today. Deere are all around the house now using the new road I dug, to eat what little...
  9. 8

    wisconsin vr4d

    i am searching for a cylinder block from a vr4d.blocks have a 4.25 bore.if one of the cylinders is cracked or broken,it is ok.i will be only using half of it,to make a 1cyl engine.
  10. J

    Allis Chalmers 'G'

    looking for info on how to increase hydraulic oil pressure from presently very low to what ever it ought to be... it won't lift the cultivators; could there be a pressure relief valve set too low???? Also looking for attachments... what have you got???
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top