-
J
Oil Pump - which brand
I just rebuilt my oil pump from the kit off this site,the kit came with a aluminum main gear which after pressing on they expect you to drill and tap a setscrew between the gear and shaft to keep it from spinning, good luck, I even took it to a machine shop and they said the drill would just...- jeff te48
- Post #1
- Forum: Harry Ferguson
-
J
torque specs
Dropped the pan, spun the main drive gear roll pin,so I'm putting the rebuild kit in,don't like the aluminum big gear that comes with the kit I think I'll press the factory steel off the shaft and see if it go on the new shaft, anybody else do this? Pros/cons on the alum. gear?What I could use...- jeff te48
- Thread
- Replies: 1
- Forum: Harry Ferguson
-
J
Oil Pressure
While mowing with my 1948 TE20 I looked down to see the oil gauge at 0, oil pressure was good when I started,oil level is good,always held good pressure{dropped a little if mowing for long periods never below 20 or so}engine has oil filter etc. pulled oil line at block no oil, engine is in good...- jeff te48
- Thread
- Replies: 5
- Forum: Harry Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy