Recent content by jeffreyi

  1. J

    John Deere vintage flail mower 25A questions

    Thanks. Yes, will probably make the parts. Checking the scrap metal pile this afternoon. I thought it kind of interesting that John Deere seems to have lost the plot on these earlier models.
  2. J

    John Deere vintage flail mower 25A questions

    My mower is made in Mexico, serial number P00025A 634385. Yes, it's old, probably 1986 vintage. The online John Deere parts manual for the 25A starts at a higher serial number. The part I am interested in are the skid plates, and two part numbers, E32111 and P57935, are listed, with a generic...
  3. J

    Case 10 sickle bar mower pitman

    My (much used) Case 10 semi-mount mower came with a metal pitman. I rebuilt the other parts, new sections, clips, wear plates, guards, belt. It was running nicely until it didn't. Investigation revealed that the metal pipe pitman is bent, and it is a cobbled up replaced part. From the...
  4. J

    John Deere 1050 clutch finger adjustment

    Thanks, everybody! I've sent an inquiry to ebay seller Mike, and worst case scenario, Big Green has one for, of course, megabucks considering what it is, a little piece of sheet metal with no moving parts. However, splitting this tractor is not something I want to do again if I can help it so I...
  5. J

    John Deere 1050 clutch finger adjustment

    I'm replacing the clutch in my John Deere 1050 4wd tractor. I ordered a new clutch from Yesterday's Tractors and now I need to adjust the clutch fingers, or the clutch release lever height. The manual specifies a special tool, a JDG-52 Clutch adjusting tool. In the photo below "A" is the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top