(800) 853-2651
SHOP NOW

Recent content by Jeremy L

Yesterday's Tractor Forums
  1. J

    MM G1000 Vista - Ampli-torc Spragg Clutch

    Has anyone ever determined the original manufacturer for the spragg clutches in the MM tractor ampli-torcs? Just wondering if sourcing one directly would be any cheaper than through Agco? Also, any idea why they made/used 3 different sizes on them? Based on my understanding our G1000 Vista...
  2. J

    G1000 Vista Steering Gear Housing Leak

    Hi, I recently noticed that there is oil being pushed out of the breather on the steering gear housing (see attached pdf). Thinking about this and after checking the dipstick on the housing which was over full, I've had to top up the power steering pump lately. I think I have oil by-passing...
  3. J

    White 2-135 2wd Wheel Lug Nut Torque

    Does anyone have a tech book that can tell me what the front 2wd lug nut torque spec is? Thanks in advance for your assistance.
  4. J

    G1000 Vista Tilt Column Cover

    This was supposed to be a reply to SWMolines Nov. 29, 2021 post with the same Subject Title. I apologize for the confusion everyone.
  5. J

    G1000 Vista Tilt Column Cover

    This message is a reply to an archived post by SWMolines on November 29, 2021 at 11:40:55. The original subject was G1000 Vista Tilt Column Cover. We used one from a salvaged White 2-105 and modified the end to fit the steering column as the Vista's column was larger in diameter. With that...
  6. J

    MM Rear Wheels (Cast Centers) - Weights

    Does anyone have an idea what the 34 (#1 in parts diagram 10A3312) and 38 (#5 in parts diagram 10A8476) wheels (cast centers) weigh?
  7. J

    White 6065 Forward/Reverse Synchronizer

    I think the forward/reverse synchro is going in our White 6065. Based on my understanding I am going to need to split the tractor just ahead of the seat to access it and that it is the top shaft accessed from the front of the transmission housing. Any experience/thoughts/suggestions from those...
  8. J

    International Tachometer

    I am looking at purchasing an international tachometer to potentially use on our MM U302 super as you can't get replacements for these. The issue I have is that I need to confirm if the international tachs are 1:1 ratio or 2:1. Any of the tachs that don't show speed or gears in them are my...
  9. J

    Oliver Tachometers

    I am looking at purchasing an oliver tachometer to potentially use on our U302 super as you can't get replacements for these. The issue I have is that I need to confirm if the oliver tachs are 1:1 ratio or 2:1. Any of the tachs that don't show speed or gears in them are my preference. I want...
  10. J

    MM U302 Super Tach Replacement

    I am being told that they are discontinued and the few other places I've tried that typically have old stock, don't have any. Was wondering about any aftermarket options or ways to make say a G1000 tach work such as a reduction adapter like those used on the backs of the old generators to make...
  11. J

    MM U302 Super Tach Replacement

    Does anyone know of a source for a replacement tachometer on a 1967 MM U302 Super? I understand the tach on these is different then say a G1000, is there internal differences (i.e. gearing) or what exactly is the difference?
  12. J

    Telescopic steering column

    Any tips or tricks to loosening up a stuck telescopic steering column on a G1000 Vista? Even the tilt is tight (rotating of the steering column). Thanks in advance for your help.
  13. J

    Diesel Tach Drive Issue

    I have a 1967 MM G1000 Vista (diesel) that's tach intermittently works. I've replaced the tach cable and the tach and have confirmed that they both work. For whatever reason, the tach cable will turn at times and everything is fine and then for no reason it may just stop working. When I...
  14. J

    MM G1000 Vista (tach drive)

    What drives the tach on the side of the engine (oil pump)? I have a new tach, new cable and at times it works and others it stops working. I also have an oil leak that has started where the tach cable attachs to the engine block. Any assistance at all would be greatly appreciated.
  15. J

    MM G1000 Vista hydraulic and transmission filters

    I am trying to source new hydraulic filters from Napa but can't seem to find what I am looking for. The parts book gives me 20P6420 for the 100 mesh strainer and 10P3062 for the filter. I can't find a NAPA replacement for the 100 mesh strainer which is located under the access stairs/steps...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top