-
J
oil pressure question
I got this tractor 1964 4000 gas about a year and a half or so ago. It had literally no oil pressure. After some looking I found the nut on the oil filter tube part no.66738 was not there. I found a new old one installed the packing and nut. OK now I have oil pressure cold 90 psi hot 70 to... -
J
Stuck clutch
if you get it unstuck try this a small u bolt and very stiff wire -
J
641 Hydraulic Parts
the unloading valve is sticking take it apart and clean it replace the o ring and leather wiper on the piston soak the leather in very hot water to get it to stretch over the piston then let it cool and dry before assembly check the cam pen its most likely worn you can reverse it or replace it... -
J
Ford Belt Pulley
if it is a multi groove it could be the drive pulley for a side mower -
J
Ford 861 Hydraulics
I use a piece of clear plastic hose to bleed the pump usually takes a few minutes also the unloading valve could be stuck or sticking and the limited lift heighth could be due a pen on the draft control lever that rides on the rocker this pen can be driven out and reversed or replaced be sure... -
J
clutch stuck
My father had an 850 he bought new when I was a kid and the clutch stuck one winter. Very hard to get unstuck but he did get it done. back to the present, our hunting club has a tractor build in India, nice machine 4 wheel drive cab over heated air, but it has a clutch lock down. So being an... -
J
New Fuel Cap Is Junk!
I under stand I purchased one for a 2N and I had to drill a small hole in it. And that worked. -
J
600 hydraulics
It is a remote and self centering and I've worked it to make sure it is centered. My brother owns this tractor and he say some times it worked and some times it didn't all though the front blade worked allways screwey huh -
J
600 hydraulics
the hyd valve in question is mounted where the blocking plate would be it is a ford product for external operations it shouldn't affect the rear arms and it they have been working for the last 2 weeks since I went through the repair I'll get a picture later today thanks for the thoughts
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy