Recent content by Jim Davis

  1. S

    compairing old C pulley to new one/ fan adjuster

    As my previous post stated, I got my new C pulley in today... immediately had to go to work.. so.. just got home at 11:15 pm and decided to run out and play a few moments.. I did a real quick go / no go test on the id of the pulley and OD of the crank snout, and od of the seal surface to the...
  2. J

    Oliver 66 grills

    Thanks. I think I'll be able to look at a whole 77 tomorrow and that should answer some of my questions once and for all. It seems I must have a nose cone from an 88, since I have two small ones and one big one. The grills seem to fit the 88 nose cone better than the two little ones, but I'll...
  3. J

    Oliver 66 grills

    Also, I just went out and looked at them again. The grill pieces seem to match up fairly well on the one large nose cone, but not on the smaller nose cone that fits my tractor! They just don't fit up right on the small one. Now what? There is no step at the lower outside corner. There is a small...
  4. J

    Oliver 66 grills

    So are all three models' grille pieces the same size-- are the 66 and 77 grille pieces interchangeable? Also-- I received 3 different nose cones with the tractor, none of which were mounted. Two were smaller, I assume one of them came with the 66. The third is considerably bigger. Is the nose...
  5. J

    Oliver 66 grills

    Hi! I bought a 1948 model 66 and it came partly disassembled. I got 5 different grille pieces with it, two for one side, three for the other. They each have seven horizontal slits in them. Other than being either left or right hand side they are identical mechanically. I tried to fit a couple on...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top