(800) 853-2651
SHOP NOW

Recent content by Jim Eubanks

Yesterday's Tractor Forums
  1. J

    NAA diff side housing gasket

    How about a 600, will the gasket from a 600 fit the NAA axle housing?
  2. J

    NAA diff side housing gasket

    Is there a difference between the axle housing gasket for a NAA and 8N? My parts book does not show a seperate gasket for the NAA but the local parts guy says he shows a different number and of course he does not have the NAA gasket in stock.
  3. J

    Auger Cutting Edge

    Make you own out of a old spring leaf. You can cut the holes with a torch. Been doing that for years and the spring metal is as good or better than the original cutting tips.
  4. J

    curved beam 3pt subsoiler

    Thats it, Ferguson D-Be-28 Sub Soiler, maybe someone on the forum will know where we can get a point for this subsoiler.
  5. J

    curved beam 3pt subsoiler

    I have an older curved beam 3pt subsoiler that needs a new point. Cannot ident. mfg. Beam with 3pt pins has dip to accomodate a coulter. Point is 8" tip to 1/2" single mounting bolt and would be reversable which would make it 16" overall. Can anyone help with brand ident? Source for pt?
  6. J

    test msg

    test
  7. J

    NAA/600-800 piston hyd pumps

    Would someone please tell me what it is that goes down in these pumps and why. I had a NAA pump go down several years ago and at the advice of a local parts guy put a new wobble shaft in it. That with new seals fixed it fine. Never could see why the old piece was bad. Pump is down again and I...
  8. J

    Ferg. subsoiler point

    Need a point for the early curved beam Ferg. 3pt subsoiler. Appears to be one bolt, approxomately 9" from whole center to end of bit and reversable. Even a used one would be great cause I could weld onto it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top