Recent content by joe1383

  1. J

    Radiator Drain Cap

    1959 Ford Workmaster 601 Replaced radiator in Oct ‘23. Somehow my radiator cock drain plug fell out somewhere. Ran to Rural King to get another 1/4” npt and I cannot get it to start the thread. Any suggestions? Almost like it’s just a micron too big.
  2. J

    WorkMaster 601 issues

    I did sorry I forgot to list it ;-)
  3. J

    WorkMaster 601 issues

    I set the main jet at counter clockwise after lightly seating 1.25 turns. I lightly seat the idle mixture screw, then turn counter clockwise 1 full turn. I start the engine and adjust the idle mixture until the idling is smooth. Then I pull the throttle to 80% or so and adjust the main jet...
  4. J

    WorkMaster 601 issues

    I have a Manuel and I have not replaced parts beside carburetor and plugs since having this issue. I tried to replace the parts slowly because the tractor is a 59 and sat outside till I bought it. So just things were weathered and cracked so I started slowly to replace them I didnt want to get...
  5. J

    WorkMaster 601 issues

    1959 Ford Workmaster 601: Dies after about 10 minutes. The only way to get it to run for that ten minutes is to adjust the carburetor. Here is a list of things that I have replaced or checked. I am stumped at this point and you all on here are super knowledgeable. Has spark, getting fuel...
  6. J

    WorkMaster 601 issues

    1959 Ford Workmaster 601: Dies after about 10 minutes. The only way to get it to run for that ten minutes is to adjust the carburetor. Here is a list of things that I have replaced or checked. I am stumped at this point and you all on here are super knowledgeable. Has spark, getting fuel...
  7. J

    Hydraulic Loader Weak

    ey all got the plug off, but not able to get the fitting off to get that screen out. I went ahead and just took the whole piece off so if I cannot figure out how to get this off maybe I can just replace it. What do you all think?
  8. J

    Hydraulic Loader Weak

    can t find a filter anywhere. Going to pull that screen out today.
  9. J

    Hydraulic Loader Weak

    Awesome I will take a look at it in the morning. I will let you know what I find. Thank You!!
  10. J

    Hydraulic Loader Weak

    I disconnected hose at the bottom of the reservoir and there is no screen present. I have attached photos so you all can see what I see. They include the controls, the reservoir with draining oil, the pump, and each cylinder (blue are lift and yellow is tilt)...
  11. J

    Hydraulic Loader Weak

    I can not find one for this front loader.
  12. J

    Hydraulic Loader Weak

    Sorry I did not note, it does drop to the ground over a period of time. When you shut the tractor off and the bucket is up you can hear it click and eventually it will be on the ground. Also after holding the control down for a long period of time and have the engine rpms high, if I try...
  13. J

    Hydraulic Loader Weak

    o Filter that I can find. A hose comes out of the bottom of the mount (which also serves as the tank) goes into the pump. From pump to controls where it is split two 3 cylinders (2 lift, 1 tilt).
  14. J

    Hydraulic Loader Weak

    I have a Freeman 3000 front loader on a 1959 Ford Workmaster 601. I purchased this setup about 2 years ago. The hydraulics were nice and strong. This spring I noticed it would take forever to lift the bucket. I checked the fluid and noticed it looked like chocolate milk. I emptied the old...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top