-
J
8n stuck oil drain plug
Bob Thank you very much sir. The brass mallet did the trick. I tapped on the plug for a pretty good while and then put the wrench back on it and it came loose. Thanks again.- John Bull
- Post #1
- Forum: Ford 9N, 2N & 8N
-
J
How high should it lift?
Is anyone going to say what the problem might be?- John Bull
- Post #1
- Forum: Ford 9N, 2N & 8N
-
J
2N for sale
Thanks for your replies. I called the seller this morning and he said it was leaking water from the block because of a head stud that has been repaired with a heli-coil. The seller said that the block would need to be drilled bigger and a new heli-coil. I decided to pass since I wasnt...- John Bull
- Post #1
- Forum: Ford 9N, 2N & 8N
-
J
2N for sale
There is a 2N for sale about 50 miles from home for $550. Looks pretty good but doesnt run. Is the 2N a good fixer upper tractor? Or should I avoid this one?- John Bull
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy