Recent content by John(IN)

  1. J

    8N Bent brake pedal

    Thanks for the reply Dell. Gonna heat it and see if I can get the individual wheel brakes going again. This N always felt awkward with those pedals overlapped and I could never get the shoes adjusted to lock both wheels at once.
  2. J

    8N Bent brake pedal

    My 49 8N had the right break pedal bent when I bought it. It overlaps the left pedal about 2 inches. Anyone know if it can be heated and straightened? It looks to be a cast part but it bent in without breaking.
  3. J

    Slow to make oil pressure

    Thanks all for the replies. I'll try the prime before startup, which I guess would indicate the pickup tube problem. If so I will pull the pan and fix it. This tractor gets very little use now so I'll likely put off the replacement of bearings and maybe run heavier oil. It starts good, runs...
  4. J

    Slow to make oil pressure

    48 8n oil pressure doesn"t come up for several seconds at startup. Maybe 5 to almost 10 seconds which seems like forever. About 30 psi when it kicks in cold and about 5 psi when hot. Where should I look for the problem first? It"s been like this for years and otherwise runs ok. Has been the...
  5. J

    New sleeve kit

    Thanks for the reply.
  6. J

    New sleeve kit

    I plan to install new sleeves and pistons in my 49 8n. Will I need to hone the new sleeves when they are installed?
  7. J

    8n engine kit

    Thanks for the reply!
  8. J

    8n engine kit

    1949 8n smokes and uses oil. Which engine kit would be recommended. The 4 ring pistons or the 3 ring pistons? Engine has .090 sleeves but I don't yet have a piston out to see what prior rebuild used. Why are the different piston options offered?
  9. J

    Putting boots on plugs wires

    I lubricate the inside of the boot with lighter fluid.
  10. J

    653 tractor track type

    I would guess the serial number would be on the frame bar just below the front grille facing up. Thats where it was on the HD4 and most things are the same on those two tractors.
  11. J

    Pictures from the G roundup

    Great photos Joe. Lots of nice equipment shown with the G's.
  12. J

    Engine project question for soundguy

    Backed into a pile of dirt and lost power. Did you dig the dirt out of the exhaust pipe or is it still in there not letting the engine breathe?
  13. J

    hd4/cat allis chalmers

    Yes they are seperate. The transmission oil level stick is under the seat and the torque converter/shuttle clutch oil level stick is under the floor by your right foot. Yes it is a 3 speed transmission with shuttle forward/reverse
  14. J

    hd4/cat allis chalmers

    The book calls for 20-20W in the transmission and for Type A in the torque convertor/shuttle clutch
  15. J

    8n hydraulic lift

    If the lift arms are going all the way to the ground it sounds like mine does when I have the long connecting links in that came with the sicklebar mower. Check the links that hook to the lift arms and make sure they are not the long (about 8") ones.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top