(800) 853-2651
SHOP NOW

Recent content by johnnykopp

Yesterday's Tractor Forums
  1. J

    farmall 400 ta

    andrew,took the cover off,the spring is not broken,i moved the throttle from top to bottom and noticed not much travel inside the governer,(there is travel with the governer spring lever)i removed the linkage from the the speed control lever on the governer and moved it by hand and did not see...
  2. J

    farmall 400 ta

    good morning,i took the screen out of the carburator and found it in good shape,cleaned it with low preasure air,i could see through it.it is open at the end,is it made that way?(that took care of the air bubble in the fuel bowl)now to open the governer,is it full of oil and will anything pop...
  3. J

    farmall 400 ta

    thank you for the info,i will give it a try this evening.does this have anything to do with the tractor not wanting to do anything more than idel?
  4. J

    farmall 400 ta

    thanks guys for your fast responce.i went to the barn to recheck the linkage,all is together,noticed that when the throtle lever is up the linkage pushes the governer lever foward,when down it pulls it to the rear..can't remember which is open or closed.i looked for a spring you talked...
  5. J

    farmall 400 ta

    help,i purchased a farmall 400 ta last fall and it ran fine.this spring it would not start.was not getting spark 1/2 the time.removed the distributor,replaced the points,condencer,rotor,distributor cap,wires and new coil.set the timing.drained old gas,replaced with new.it started right up and...
  6. J

    ford 515 sickle bar mower

    hay guy's,thank you for the information.this has helped me to make a purchase.i just planted a few acres of alfala and getting ready for cutting next spring.thank's again and happy trails till we meet again,johnny
  7. J

    ford 515 sickle bar mower

    howdy,does anyone know if a 8n ford or ferguson to30 have enough horse power to operate a ford #515 sickle bar mower?the mower was on a ford 900 tractor don't know its horse power.the 8n has 27.3 at belt pully and23.2 at draw bar.the TO30 has 30 hp.any info. or experence's will help.thank...
  8. J

    to 30

    howdy.help,i have a working 52 to-30 that seems to be starving on fuel at open throtel while pulling a disc after working for a while.i notice air bubbles in fuel strainer bowl and presure build up in the tank,[have vented fuel cap]also looks like fuel is boiling in tank.had not seen this happen...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top