(800) 853-2651
SHOP NOW

Recent content by jordan8

Yesterday's Tractor Forums
  1. J

    TEA20

    Also having a oil pressure issue. When I aquired the tractor it was pretty well used and abused. There was low oil pressure (10lbs start 0 running)so I replaced the filter, gauge and changed the oil.When I started it, it was at 40lbs for about 5 minutes and then went to almost 60lbs and now i'm...
  2. J

    TEA20

    I have the metal pipe that attaches to the valve cover with the correct bolt, and goes to the intake and threads in. It's the were it bolt's to the intake that there is no hole.I'm thinking that I need to drill the intake to open it up.
  3. J

    TEA20

    On the valve cover to the intake hose should there be a hole in the intake were it threads in.Mine does not have a hole and look's like it was never there? I know there is a reason the pipe is there and seem's like there should be a hole.
  4. J

    Smoking to30

    Forgot to add that I ran the tractor for a hlf hour and then pulled the plugs and did another comp test 63lb 78lb 82 lbs 74lbs.Let it sit for a hour and the comp was all over 100lbs. When i pulled the heads the pistons were all full of oil. The intake ports seem dry with no oil residue.
  5. J

    Smoking to30

    Boring winter day so I started to tear it down. The was no marking or chanfer on the rings to show right side up. They did look new. I slid one in and there's at least 1/4" end ring gap. When I was sliding the piston out from the bottom they would fall down in the cyl from the top if your wood...
  6. J

    Smoking to30

    Plugs are black powder looking.They were not wet looking like to much fuel.The smoke is blue and smells like burning oil.
  7. J

    Smoking to30

    The guage I use on my other items and seems to be correct.The rebuild was 2 seasons ago and the guy gave up on it after it smoked.He put a few tanks of gas through it in hopes that the rings would seal.Gas is fresh and carb cleaned with fresh rebuild kit.
  8. J

    Smoking to30

    Just picked a 54 to30 that smokes. Comp on all 4 cyl is 150lbs. The guy I got it from put new piston rings in it.Comp seems high.Is it possible that oil is getting by the oil ring oer maybe valve guides
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top