(800) 853-2651
SHOP NOW

Recent content by Jpc3

Yesterday's Tractor Forums
  1. J

    Deere 310D reverser not working

    Thanks Jim. Following up on your suggestion
  2. J

    1991 John Deere 310D Reverser not working probably

    Thanks everyone for all your suggestions. This is an older 310D with a reverser solenoid manifold that has been discontinued. Deere Part number is AT163601. Narrowed problem down to the coil that controls reverse. Deere doesn't sell that part except as part of $7K manifold assembly. So far...
  3. J

    Deere 310D reverser not working

    Thanks JD Dave. Mechanic checked the electric connections and all good except the coil controlling reverse which operates only intermittently. Looking for used one or place to purchase aftermarket version of Deere part AT163601. Thanks! Joe
  4. J

    Deere 310D reverser not working

    Hi, Old machine with original version of reverser solenoids that will not go into reverse. Problem is intermittent. Mechanic thinks it's the solenoids but replacement part for this runs more than $7K, which is more than the machine is worth. Any ideas about how to proceed? Good aftermarket...
  5. J

    1991 John Deere 310D Reverser not working probably

    Hi, My old backhoe doesn't go backwards. Problem is intermittent. We've changed the reverser oil and cleaned the screen. Local mechanic thinks its the reverser solenoid. Trouble is this is the early machine and the replacement part from Deere (AT163601) sells for $7000+. Wondering if anyone...
  6. J

    Fuel priming CAT D3B DOZER

    Update: I followed your advice -- topped off the fuel tank, opened the bleeder at the filter outlet and waited. Eventually watched a bubble or two then just a steady but never a real strong drip. Engine wouldn't kick, so we started from scratch and opened and bled each connector along the...
  7. J

    Fuel priming CAT D3B DOZER

    Thanks for the tip. (and for not laughing!) I'll let you know.
  8. J

    Fuel priming CAT D3B DOZER

    Just left a D3B in the middle of the trail. 300 miles from here. Just dropped power and died. Possible that it ran out of fuel although not sure. This unit doesn't have a priming plunger. Any suggestions as to how to prime? Thanks!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top