-
J
640 wont stay running
My 640 will start and idle for a couple of minute Then sputter and die, I have rebuilt carb, New plugs and wires, new cap and coil. I have great fuel flow, thought maybe was a venting Issue on the cap but that wasnt the case, any ideas??? -
J
siemens electric motor
We used to have junkies come by our pump Repair shop, they would pay $1.00 per HP Working or not -
J
MN brown red snow
I?m in NW Texas and yes the wind was crazy here Tuesday and Wednesday, blowing 30-40 All day out of the S-SW , sky was dusty red All day- Jtex
- Post #1
- Forum: Tractor & Farm Talk
-
3
Torch update
Well thanks for all the replies. I have decided to try propane and realize it has its limitations. If I don't like it, all I will be out is the cost of a tip. I always have propane for the grill and camper so it does make sense. I will also keep a bottle of acetylene on hand in case I want... -
J
Pump inlet/outlet?
you can reduce the discharge but the suction line must be as big or bigger than the pump suction size, if not the pump will cavitate and cause you damage to the pump -
J
side business idea
popular here in Texas wheat country, clean seed wheat, several people have businesses that come to you and clean it.- Jtex
- Post #1
- Forum: Tractor & Farm Talk
-
J
sliding barn doors
Keep in mind I'm from Texas, very few wood barns here, all pipe, and steel purlins with factory R panels for sheeting, takes that much clearance for the door to clear the ribs of the sheets My dad and myself built every 3600 sq ft of it.- Jtex
- Post #1
- Forum: Tractor & Farm Talk
-
J
sliding barn doors
I have sliding doors on my barn, anyone ever come up with a good way to seal the 2-3 inch gap between the door and barn wall, when they are closed the cold air whisltes right around the ends. I tried some flat rubber sheet but after about 6 months it cracked and fell off around the screws. any...- Jtex
- Thread
- Replies: 23
- Forum: Tractor & Farm Talk
-
J
Nevada flooding
as stated in other posts they are "frac tanks" used in the oil fied, and any other place that needs to store fluid. They are built 2 miles from my shop in WIchita Falls TX, by Wichita Tank MFG. see many of the Rain for Rent blue ones go by my office every week. at one time when things were...- Jtex
- Post #1
- Forum: Tractor & Farm Talk
-
J
kinda ot - how to move something big
Cool pics, thanks for posting- Jtex
- Post #1
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy