(800) 853-2651
SHOP NOW

Recent content by Jvoss

Yesterday's Tractor Forums
  1. J

    GB Diesel help

    Its still got the Bosch pump on it. And Im sure its turning that Ive checked it with multiple tachs. And Ive upped the fuel already. Thinking about messing with the intake for more air. And yes I might consider the jugs and stuff when I restore the tractor. Will that also help with higher...
  2. J

    GB Diesel help

    Ok around what rpms do these engine start to float valves? Its running about 1750 right now. Stock springs.
  3. J

    GB Diesel help

    Ok around what rpms do these engine start to float valves? Its running about 1750 right now. Stock springs.
  4. J

    GB Diesel help

    This message is a reply to an archived post by mightymolinekid on January 17, 2012 at 04:56:20. The original subject was Re: GB Diesel help. Ive got a gbd Ive started pulling with and Id like some more info on how exactly to advance the timing correctly/accurately on it. If you could shoot me...
  5. J

    Moline GB Diesel intake heater

    Its got a spark plug in the intake and a ignition coil mounted next to it and then fuel lines running back to the hand pump at the operators station. Not even sure if it works just wondering how youre supposed to use it technically. Acouple pumps and then hit the switch? Is it suppose to have a...
  6. J

    Moline GB Diesel intake heater

    Recently purchased a GB diesel. Everything is there and hooked up for the intake heater set up but Im wondering how exactly it should work?? How do operate the pump and switch in the correct way for starting?? Thank you Also it has no serial number plate anywhere on the tractor. How can I...
  7. J

    Farmall MD 12v generator system

    Also since I had already polarized the gen with it running do I need to do anything over since it was supposed to be off? Or will it stay polarized or hurt anything since I did wrong the first time
  8. J

    Farmall MD 12v generator system

    Thank you that test to check the reg I will do tomorrow that was a big help!
  9. J

    Farmall MD 12v generator system

    Thank you for you response. I will look into that stuff. Just out of curiosity could a ground issue cause anything? I made sure the battery ground was free of paint but where the reg mounts to the tractor it has fresh paint under there if that affects anything?
  10. J

    Farmall MD 12v generator system

    I didn’t touch the field on the reg or the field on the gen. I was told jump the bat on the reg to the A on the generator. Little spark and it started charging. I was told anytime you break the charging circuit you have to re polarize the gen that correct? If I break the ground from the battery...
  11. J

    Farmall MD 12v generator system

    Recently restored my 1951 Farmall MD. Had the generator rebuilt, brand new voltage regulator and brillman reproduction wiring harness. Everything is wired and ground like it should be I think. Gauge shows discharge with tractor off and lights on like it should. Good battery. Fired the tractor...
  12. J

    1951 Farmall MD turning up injection pump

    Wondering if I could get any tips or info on how to turn up the injection pump to get more fuel or rpm on my MD. Not trying to go crazy and break something just want alittle more power for tractor pulls.
  13. J

    Farmall MD magneto wiring order

    I heard on an MD with a magneto the firing order is the same as a regular M. 1-3-4-2 but they rotate counterclockwise correct? Starting at 1 on the cap it should look like 3-1 4-2?? I?m making this more complicated in my head than it needs to be I think
  14. J

    1951 Farmall MD intake switch for magneto?

    Working on getting an old MD running. The ground wire that goes from the mag to the intake is bad and cracked. Idk if the switch that grounds it is even good anymore either. I was wondering where I could get a switch and wire I can?t find them anywhere online?? Or should I just run another wire...
  15. J

    1948 Case SC headlights/mounts

    I have been restoring a 1948 Case sc and it did not have the correct headlights or mounts. It does have the bracket that goes under the fuel tank. If anyone has any info of where I can get the correct headlights and mounts I would appreciate it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top