Recent content by k ohls

  1. K

    points gap

    can anyone tell me the points gap for a 49 8n thanks so much
  2. K

    Manual for 8n

    Will the manual for the 8n tell me how to rebuild the steering gear box. I have remove it from the tractor and am trying to decide if I should try to rebuild it or buy a used one. It would not turn to the left. The steering wheel would like unscrew when I tried to turn to the left. It would...
  3. K

    value removal

    thanks
  4. K

    value removal

    Bruce when you say pump base do you mean the sump for the middle, meaning the middle drain plug area? If I use a hand sprayer do I need to worry about getting any into the tranny or rear end? Again thanks Keith
  5. K

    value removal

    when you say flush 5 or 6 times what are you flushing the diesel with? or are you just meaning flush 5 or 6 times with the diesel and let it drain over night. the refill with new oil.
  6. K

    value removal

    I have a part of a manuel but not the part of pulling out the valve, I just replaced all the oil according to # 3 and 4 in your link and hand cleaned out the sludge. The valve seamed sticky like I had to move it past the stops and I pressure leaked off over night. In the manuel I, had it talked...
  7. K

    value removal

    sure can make a feller feel dumb :oops:
  8. K

    value removal

    To remove the lift cover do I just remove the four bolts behind the handle that raises and lowers the hydraulics? Is that the lift cover?
  9. K

    value removal

    It is the hydraulic control valve (I think) the one that controls the lifting of the hydraulics I looked to find a way to delete this post and start over after I saw I spelled the subject wrong
  10. K

    value removal

    I did a search but could not find any how to 's on removing the valves and cleaning it up
  11. K

    value removal

    that would help a lot its a 8n I don't what year
  12. K

    value removal

    How do I remove the hydraulic value? thanks for your help Keith
  13. K

    wont lift

    That is it Bruce I did not have any thing on the back to hook the chain. So I put the blade on and was able to use the chain making the bucket work. Thanks so much for your help
  14. K

    wont lift

    I changed all the oil. And now the back works but I cant get the front bucket to go up. There is a chain in the back axel dose it go over the lifting arm so the front will start lifting? If I change the value that stops the oil from going up to the bucket do I have to do some kind of bleeding?
  15. K

    wont lift

    saw that after the fact going to replace it now
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top