(800) 853-2651
SHOP NOW

Recent content by kb9r

Yesterday's Tractor Forums
  1. K

    Need help identifying step on my JD "B"

    Thanks Mike, Now I know it was not a local fabrication. Hopefully we will hear from others on this step. Joe
  2. K

    Need help identifying step on my JD "B"

    Hello friends, Does anyone have any information on the step on my 1935 "B"? I thought my Dad may have fabricated the step back in the 50's or 60's. However a number of years ago, I saw an identical step on a tractor on the internet. So, I am assuming this was a commercial aftermarket item...
  3. K

    WICO XH1042 magneto

    Rich, Yes, I'm probably thinking to deep. Before I rebuild the entire mag, I will look at the cap, rotor, points & condenser. Good advice! Joe
  4. K

    WICO XH1042 magneto

    Dan, Thank you! Now that answers my initial question! I appreciate your efforts along with others to help me! Joe
  5. K

    WICO XH1042 magneto

    Thanks for all the info guys! Well, I just need to pull my mag and measure the lugs I guess. I couldn't remember if they were long or short. The reason I asked, is I was under the impression that the XH1042 was a short lug mag built after 1940. Maybe they made them both ways or the lug piece...
  6. K

    WICO XH1042 magneto

    I have a 1935 B with a WICO XH1042 magneto. This is probably not the original magneto. I think that may have been a Fairbanks & Morse DRV2B? My question is this: Does this tractor and this WICO magneto have a short or long ear assembly? Currently the tractor runs, but starts hard. I...
  7. K

    john deere 318

    Thanks Bob, Your information is very helpful! Joe
  8. K

    john deere 318

    Bob, Can you give us so more info on the low pressure pump? Is it from John Deere or who? Does it go in the tank or external? Where do you connect to wiring? Thanks, Joe
  9. K

    35 B hood removal

    Thanks for the info guys! That helps. Joe
  10. K

    35 B hood removal

    Hello friends, What is the best or easiest way to remove the hood on a 1935 John Deere B. I assume the steering shaft needs to be addressed? Thanks for any advice, Joe
  11. K

    Step for unstyled John Deere B

    Excellent point Mike! When I back it in the shed, the rear wheels are against the back wall, so it makes it hard to get on. However, I would hate to get my clothes tangled in the flywheel, so that is solid advice. Thanks, Joe
  12. K

    Step for unstyled John Deere B

    Hello friends, I'm looking for advice or pictures of a step for my 1935 B John Deere. My first preference would be in front of the axle by the flywheel and second choice behind the axle. Thanks for any suggestions or pictures. Joe
  13. K

    318 with no hydraulics

    Do you have a diverter valve on the tractor to switch between front and rear hydraulics? Did some one adjust the rear cylinder travel stop? Good luck, Joe
  14. K

    Need Tire/wheel flap for 6x36 rim

    Does anyone have a source for the tire flap for a 6 x 36" rim. This is the rubber band that goes over the spokes to protect the inner tubes. This is on a 1935 "B" John Deere. Thanks for any help, Joe
  15. K

    John Deere 318 Runs Rough

    Hi Bill, I had a problem like yours and it turned out to be the gasket and mating surfaces between the intake manifold and the block. I found it by spraying some WD-40 in those areas. When I hit the leak, the engine instantly ran better. (careful about fire hazard). So I changed gaskets and...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top