-
KKell replied to the thread looking for air cleaner winged bolt for Oliver 1950.you could make one.
-
KKell replied to the thread 1755 Fresh Overhaul Over Fuel ?.gray wld be unburnt fuel, white wld b coolant, but i'm sure some do describe gray as white. diesels don't seem to run for long if you...
-
KKell replied to the thread Hey Randy!!!.great compliment! i really appreciate well writ articles & papers; esp now, w calculators writing a lot of content. where is Randy's...
-
KKell replied to the thread Substitute for Type A transmission fluid.dex3 in every unit i've ever owned. never a prob w O/D clutch, U sprag, [or bearing] wear, but i've rebuilt a couple for other reasons...
-
KKell replied to the thread WTB: Underslung 1655.easier to find a normal RC & buy the front axle you want separately from salvage. usually can find the axles on CL or FBMP if you don't...
-
KKell replied to the thread More 1955 hydraulic questions..a few other spots you'll love: rear air cleaner nuts, replacing steering valve oil lines, lower radiator hose, inside/bottom nut on the...
-
KKell replied to the thread More 1955 hydraulic questions..lol. fun times. it is a CF on that side w 4 hoses for dual remotes, pto valve lines, and the cat3 cyl and hose. you can drop the cat3...
-
KKell replied to the thread 310 Diesel oil pressure.if the main relief spring isn't broken, just shim it and see if the pressure increases. if it doesn't, you might have a problem with the...
-
KKell replied to the thread Oliver 1650 Hydraulic noise/temp?.the main thing with the interlock valves and main spools is being clean and free of burrs/deformations. was there any grit/hard stuff...
-
KKell replied to the thread 310 Diesel oil pressure.those equipped w coolers had additional bypass/relief valves for the cooler and bypass filter circuits, but that doesn't change the...
-
KKell replied to the thread Oliver 1650 Hydraulic noise/temp?.190F seems too hot unless it's 110F ambient and the system is getting worked. there is a small metal tray under the pump inlet that is...
-
KKell replied to the thread 310 Diesel oil pressure.is the 15-17psi by the gauge on the dash? if so, check it with a good test gauge at the rear of the block. should be 25-30psi hot at...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy